User manual PHILIPS QT 4090

[. . . ] Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Beard trimming Always comb your beard or moustache with a fine comb before you start trimming. Trimming with trimming comb The hair length settings are indicated in millimetres on the display of the appliance. The settings correspond to the remaining hair length after cutting. the trimming comb cuts hair to a length of 1-18mm. If you trim for the first time, start with the maximum hair length setting (18mm). 7) , The display shows the selected hair length. Note: During trimming, you can use the turbo function for extra suction power and trimming speed (see section `Turbo function' below). 4 To trim most effectively, move the appliance against the direction of hair growth (Fig. Note: Make smooth and gentle movements and make sure the surface of the trimming comb always stays in contact with the skin. Note: Do not move the appliance too fast. 5 Switch off the appliance after use and clean it (see chapter `Cleaning'). Creating a stubble look Use the trimmer with the trimming comb set to a hair length of 1mm to create a stubble look (Fig. 5mm, use the trimmer without the trimming comb attached. Trimming without trimming comb Use the trimmer without trimming comb to trim full beards and single hairs. 2 Make well-controlled movements and touch the hair lightly with the cutting unit. Shaping with the precision trimmer (QT4090 only) You can use the precision trimmer to shape your moustache and sideburns, to define contours and to cut single hairs. 4 When you use the precision trimmer, hold the appliance in such a way that the trimmer points upwards and make downward strokes (Fig. Turbo function You can use the turbo function for greater suction power and increased cutting speed. When you switch off the appliance, the turbo function is deactivated automatically. Absorbing cut hairs The vacuum system is activated automatically as soon as you switch on the appliance. It absorbs cut hairs during every kind of use, i. Trimming with and without trimming comb and contouring. [. . . ] 23) Removing the rechargeable battery Do not connect the appliance to the mains again after you have opened it. Follow the steps below to remove the rechargeable battery. 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. 3 Remove the 4 screws inside the hair chamber with a screwdriver (Fig. [. . . ]