User manual PHILIPS RFX9400

[. . . ] When start-up has finished, the Power and WiFi LEDs are green. If there is already an Extender with ID 0, set the Extender ID switch to an ID that is not used yet. ⷠIf there is any interference with other products in or around the house, the Configuration switch can be set to a different RF channel. ⷠMake sure the same Extender ID and RF channel are used on the Extender and the Pronto Control Panel. [. . . ] The Extender is busy processing a long macro from the Control Panel. Refer to the topic `The Extender cannot communicate with the Refer to the topic `The IP address wireless network' on page 8. There is another AV-component in the network that is using the same fixed IP address as the Extender. When using the Extender: make sure that the Extender is connected to the router with a straight Ethernet cable. When configuring the Extender: make sure the PC is not using a fixed IP address but is using DHCP instead. If the router is using DHCP, the Extender's IP address cannot be determined. Make sure to use the correct network settings on the router. The Extender cannot communicate with the wireless network Make sure that you filled in the correct secret in the Configuration Tool. Check the router's network settings and make sure that it can operate with the Extender. ⷠIf the LED doesn't stop blinking, unplug the power adapter, wait a few seconds, and plug it in again. 3 Make sure the Control Panel is configured to operate with the AV-component. 4 Move the emitter across the front panel of the AV-component, and at the same time, send commands with the Control Panel to the AV-component. Take note of when the AV-component reacts to the IR signals of the emitter. The AV-components do not respond to commands from the Extender ⷠCheck if the Busy LED blinks green when you send a command with the Control Panel. If the Busy LED does not blink, the Extender is not receiving commands from the Control Panel; · Make sure that the switches on the Extender are set correctly. If the Wireless Access Point is placed higher or lower than the Extender, place the Extender's antenna horizontally for optimum range. Using the Extender ID switch, assign a unique ID to each Extender in the same Pronto Network. make sure the Control Panel is configured accordingly in ProntoEdit Professional. You can use up to 16 different Extenders in the same Pronto Network. The Busy LED blinks green when the Control Panel is not in use This does not mean that something is wrong with the Extender. It merely indicates that the Extender is being operated by a different Control Panel. When the Busy LED stops blinking, you can use the Extender again. [. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rule. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]