User manual PHILIPS RFX9600

[. . . ] This is useful when you suspect that the IR signal is too strong for the receiving AV-component, or when you connect the IR port to an external IR-bus system. When the Control Panel sends out a macro to switch multiple AV-components on or off, discrete codes are normally used to ensure the state of the component. In some cases, only toggle codes are available: one command toggles between the on and off state, and there is no separate command for switching the component on and switching it off. In this event, the system may get out of sync. [. . . ] 2 Make sure that the PC is switched to DHCP while the Extender is in configuration (normally, this should already be the case). After start-up, the Power and Ethernet LEDs are green and the Busy LED is red/green blinking. 5 Type the IP address of the Extender in the address bar of the browser: 192. ) You may have to refresh the browser before the Configuration Tool appears. 6 Make sure you have the IP address and netmask at hand, and follow the onscreen Reconnect it to the router with a straight Ethernet cable. Configuration through a router 1 The Extender is already After start-up, the Power and Ethernet LEDs are green and the Busy LED is red/green blinking. 6 Make sure you have the IP address and netmask at hand, and follow the onscreen Reconnect it to the router with a straight Ethernet cable. The Extender's IP address is being determined. The Extender is busy processing a code or short macro from a Control Panel. The Extender is busy processing a long macro from a Control Panel. There is another AV-component in the network that is using the same fixed IP address as the Extender. When using the Extender: make sure that the Extender is connected to the router with a straight Ethernet cable. ⷠWhen configuring the Extender: make sure the PC is not using a fixed IP address but is using DHCP instead. If the router is using DHCP, the Extender's IP address cannot be determined. Make sure to use the correct network settings on the router. 3 Make sure the Control Panel is configured to operate correctly within the Pronto 4 Move the emitter across the front panel of the AV-component, and at the same time, send commands with the Control Panel to the AV-component. Take note of when the AV-component reacts to the IR signals of the emitter. The AV-components do not respond to commands from the Extender ⷠCheck if the Busy LED blinks green when you send a command with the Control Panel. If the Busy LED does not blink, the Extender is not receiving commands from a Control Panel. Make sure that the switches on the Extender are set correctly. Using the Extender ID switch, assign a unique ID to each Extender in the same Pronto Network. make sure the Control Panel is configured accordingly in ProntoEdit Professional. [. . . ] Operation is subject to the following two conditions: · This device may not cause harmful interference. ⷠThis device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rule. These limits are designed to provide reasonable protection against harmful interference in residential installations. [. . . ]