User manual PHILIPS RI8525

[. . . ] € 15 • Italiano Guasto Cause possibili Rimedio IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or appliance in water or other liquid. Close supervision is necessary when the appliance is used by or near children. Unplug from outlet when not in use and before cleaning. [. . . ] Wait for a few seconds after brewing, then remove the cups of coffee. 19 After brewing, wait until the " " coffee light (14) stops blinking, then remove the pressurized filter holder by turning it from right to left and empty the remaining coffee grounds. 1 Filter Holder Warm-Up If the "rinse" function is not activated and/or the filter holder is to be warmed-up manually, do as follows: • 13 Insert the pressurized filter holder into the brew unit (4) from the bottom. € 14 Turn the pressurized filter holder from left to right until it locks into place. release the pressurized filter holder grip. The handle will turn slightly to the left. this movement guarantees optimum filter holder performance. € 17 Preheat the pressurized filter holder by pressing the (13) button; some water will flow out of the pressurized filter holder (this operation is necessary only for the first coffee). € After 50 cc of water have been dispensed, press the (13) button again to stop the dispensing procedure. € 19 Remove the pressurized filter holder by turning it from right to left and then drain the remaining water. place a container under the dispensing spout. Now you can go on with the coffee brewing procedures described in the following sections. € Note: a small quantity of water remains in the pressurized filter holder. This has to be considered as absolutely normal and is due to the filter holder characteristics. Important note: the filter (23) should be kept clean to guarantee perfect results. 3 Using Coffee Pods • • • • 9 Remove the ground coffee filter (23) from the pressurized filter holder (21). 10 Insert the pod adapter (24) into the pressurized filter holder (21) ensuring that its convex part faces down. 11 Then insert the pod filter (25) into the pressurized filter holder (21). 12 Insert the pod into the filter holder; make sure that the paper of the pod does not stick out of the filter holder. € 22 • • • • • • • 13 Insert the pressurized filter holder into the brew unit (4) from the bottom. 14 Turn the filter holder from left to right until it locks into place. 15 Take 1 preheated cup and place it under the filter holder. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment • 26 • Problem Possible Causes Solution The machine is not connected to the elecConnect the machine to the electric network. Fill the tank up with water and prime the circuit The pump is very noisy. Make sure the tank is full and fully inserted and The (14) " ", (18) " " and This is the first start-up or the machine is lower the temperature as described in section (20) " " lights blink simultaoverheated. [. . . ]