User manual PHILIPS RI 9376

[. . . ] When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or appliance in water or other liquid. Close supervision is necessary when the appliance is used by or near children. Unplug from outlet when not in use and before cleaning. [. . . ] The machine is now ready to brew coffee and dispense steam. It is therefore essential to follow the safety regulations carefully. Faulty cords and plugs must be immediately replaced by authorized service centers. appliance voltage has been pre-set by the manufacturer. Check that the power voltage matches the indications on the identification plate located on the bottom of the appliance. Check that the ON/OFF button (17) is not pressed before connecting the machine to the power supply. The power cord is located inside the machine. 3) - Place the power cord correctly, so that it does not interfere with the water tank. Fit the plug into a wall socket with suitable power voltage. During this operation, the brew button (15) may flash on and off; this is to be considered as standard operation and not a fault. Before using the machine, make sure that the hot water/ steam knob (3) is closed and that there is enough water in the tank. Wait until the brew button light (15) turns on. The machine is now ready for coffee brewing. Using ground coffee 2) - Lift the suction pipe and remove the water tank (5); make sure not to damage the water suction pipe. 4) - rinse the tank and fill it with fresh drinking water taking care not to overfill. 5) - Lift the suction pipe and fit the tank back into its housing. 6) - Correctly replace the water suction pipe into the tank; and place the cover back onto the tank. Only use fresh, non-sparkling drinking water tofillthetank. warmorhotwater , oranyother liquid , may damage the tank. Do not turn on the machine with empty water tank: always make sure there is enough water in the tank. Before starting up the machine, after long storage and when the water has been used up, be sure the machine's water circuit has been primed. Wait until a steady jet of water flows out of the steam spout (Pannarello). [. . . ] 17) - to clean the Portafilter proceed as follows: - remove the filter, wash it thoroughly with hot water. - remove the adapter (if fitted), wash it thoroughly with hot water. Do not dry the machine and/or its components using a Put unused appliances out of service. Disconnect the plug from the socket and cut the electrical cord. [. . . ]