User manual PHILIPS RI9836

[. . . ] When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or appliance in water or other liquid. Close supervision is necessary when the appliance is used by or near children. Unplug from outlet when not in use and before cleaning. [. . . ] This amount may be reprogrammed to your taste. Each button may be individually programmed for a specific brew setting. As an example, the following procedure describes the programming of the button " ", which is normally associated with espresso coffee. Note: Should the machine not brew coffee, make sure that the water tank contains water. Before brewing coffee, check the messages on the display. Check that the water tank and coffee been hopper are full. Leave the dial on the coffee position " " during the dispensing phase. Before brewing the coffee, adjust the height of the brewing head according to your needs, and select the aroma or the pre-ground coffee. Most cups on the market can be used with this coffee machine. The height of the dispensing head may be adjusted to better fit the dimensions of the cups that you wish to use. Manually move the dispensing head up or down to adjust its height by placing your fingers as shown in the figure. Selection must be made prior to brewing the coffee. The system sets the aroma according to the personal taste of the user. After selecting "Strong Aroma", the function for brewing coffee with pre-ground coffee is displayed. To brew coffee, press and release one of the following buttons: the " " button to select the desired aroma. The brewing cycle then starts: To dispense 1 cup of coffee, press the button once. This icon will be displayed: To dispense 2 cups of coffee, press the button twice. This icon will be displayed: To brew 2 coffees, the machine automatically grinds and doses the correct amount of coffee. Brewing two coffees requires two grinding cycles and two brewing cycles, which the machine carries out automatically. After the prebrewing cycle, coffee begins to come out of the dispensing head. Coffee brewing stops automatically when the pre-programmed level is reached; however, it is possible to interrupt coffee brewing by pressing the button initially pressed. Two cups/mugs can be placed under the dispensing head for brewing two coffees at the same time. [. . . ] The brew group automatically returns to the correct position. Remove the dregdrawer first, then the brew group. the machine grinds the coffee beans but no Water tank is empty. Fill the water tank and prime the circuit (section coffee comes out. [. . . ]