User manual PHILIPS RQ1075

[. . . ] Introduction Thank you for buying this Philips shaver. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. Important Read this user manual carefully before you use the shaver, the Jet Clean System and the Power Pod. Save the user manual for future reference. [. . . ] 6 Press the on/off button once to switch off the shaver. , The display lights up for a few seconds and then shows the remaining battery capacity (RQ1090/ RQ1062/RQ1060 only). Then press the shaving unit downwards (2) to attach it to the shaver (`click'). Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. - The best and most hygienic way to clean the shaver is in the Jet Clean System. You can also rinse the shaver under the tap or clean it with the brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. - Clean the shaver after every shave for optimal shaving performance. - You can clean the outside of the shaver with a damp cloth. - Regular cleaning guarantees better shaving performance. Cleaning the shaving unit in the Jet Clean system The Jet Clean System has three cleaning programs: the eco program, the normal program and the intensive program. the shaver automatically chooses the appropriate cleaning program. Preparing the Jet Clean system for use Fill the cleaning chamber before first use. Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). , The cleaning chamber remains behind. Unscrew the cap from the bottle with cleaning fluid and remove the airtight seal. Make sure the release buttons click back into place. , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , The cleaning light flashes throughout the cleaning program, which takes to 6 minutes, depending on the cleaning program. , During the first phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down. , During the second phase of the cleaning program , the shaver is placed in the drying position , indicated by a flashing drying symbol. [. . . ] Why isn't the shaver entirely clean after I cleaned it in the Jet Clean System?- The cleaning fluid level may be too low. If the fluid volume in the cleaning chamber drops below the minimum level during the cleaning program, the program aborts. The cleaning light and the `cleaning chamber empty' symbol flash at intervals and the holder returns to its starting position. [. . . ]