User manual PHILIPS RQ1155

[. . . ] Always here to help you Register your product and get support at www. Com/welcome RQ1100 series User manual 1 RQ119x, RQ118x, RQ117x, RQ116x, RQ115x, RQ114x, RQ113x ENGLISH 4 DANSK 27 SUOMI 50 FRANÇAIS 72 NEDERLANDS 95 DEUTSCH 118 ΕΛΛΗΝΙΚΑ 141 ITALIANO 166 NORSK 189 ESPAÑOL 212 PORTUGUÊS 235 SVENSKA 258 TÜRKÇE 280 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] Then press down the Beard Styler attachment (2) to attach it to the shaver (‘click’). Using the Beard Styler attachment with comb You can use the Beard Styler attachment with the comb attached to style your beard at one fixed setting, but also at different length settings. The hair length settings on the Beard Styler attachment correspond to the remaining hair length after cutting and range from 1 to 5mm. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 16 ENGLISH 5 Reattach the shaving head holder to the bottom part of the shaving unit (‘click’). Cleaning the shaving unit in the Jet Clean System (RQ1197CC, RQ1195CC, RQ1185CC, RQ1180CC, RQ1175CC only) The Jet Clean System has an automatic cleaning program. When you press the on/off button, the Jet Clean System starts cleaning in this automatic cleaning program. Preparing the Jet Clean System for use Fill the cleaning chamber before first use. 1 Put the small plug in the Jet Clean System. , , The holder automatically moves to the highest position. 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). , , The cleaning chamber remains behind. 4 Unscrew the cap from the bottle with HQ200 cleaning fluid. € 5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. 6 Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. This guarantees an optimal lifetime for the cleaning fluid. ENGLISH 17 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). [. . . ] RQ1197CC, RQ1195CC, RQ1185CC, RQ1180CC, RQ1175CC only: The Jet Clean System has not cleaned the shaver properly, because the cleaning fluid in the cleaning chamber is soiled or the cleaning fluid level is too low. ENGLISH Problem The shaver does not work when I press the on/off button. The shaving head holder is soiled or damaged to such an extent that the motor cannot run. The temperature of the shaver is too high. [. . . ]