User manual PHILIPS RQ1155/81 SENSOTOUCH 2D

[. . . ] Always here to help you Register your product and get support at www. Com/welcome RQ1100 series User manual 1 RQ119x, RQ118x, RQ117x, RQ116x, RQ115x, RQ114x, RQ113x ENGLISH 4 DANSK 27 SUOMI 50 FRANÇAIS 72 NEDERLANDS 95 DEUTSCH 118 ΕΛΛΗΝΙΚΑ 141 ITALIANO 166 NORSK 189 ESPAÑOL 212 PORTUGUÊS 235 SVENSKA 258 TÜRKÇE 280 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] Preparing the Jet Clean System for use Fill the cleaning chamber before first use. 1 Put the small plug in the Jet Clean System. , , The holder automatically moves to the highest position. 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). , , The cleaning chamber remains behind. 4 Unscrew the cap from the bottle with HQ200 cleaning fluid. € 5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. 6 Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. This guarantees an optimal lifetime for the cleaning fluid. ENGLISH 17 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). 3 Press the on/off button on the Jet Clean System to start the cleaning program. , , The shaver display stops showing the charging indication. , , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , , The cleaning light flashes throughout the cleaning program, which takes a few minutes. , , During the first phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down. , , During the second phase of the cleaning program, the shaver is placed in the drying position, indicated by the flashing drying symbol. The shaver stays in this position until the end of the program. [. . . ] Problem You have not placed the shaver in the The shaver is not fully charged after I charge it charger/Jet Clean System properly. For at få fuldt udbytte af den support, Philips tilbyder, skal du registrere dit produkt på www. -- Shaveren og Jet Clean-systemet bør holdes uden for børns rækkevidde for at sikre, at de ikke kan komme til at lege med apparaterne. 1 Tryk én gang på tænd/sluk-knappen for at tænde for shaveren. [. . . ]