User manual PHILIPS RQ1195/21

[. . . ] Wir helfen Ihnen jederzeit Register your product and get support at www. Zusätzliche Informationen Typennummer Jet Clean System HQ200 Reinigungsflüssigkeit Langhaarschneider Bart-Styler-Aufsatz RQ1195 ✓ ✓ ✓ ✓ ✓ ✓ RQ1175 RQ1155/80 RQ1155/16 RQ1151 ✓ ✓ English 33 Table of contents Introduction 34 Important 34 General 34 Jet Clean system (RQ1195 only) 36 Compliance with standards 36 General description 37 The display 38 Charging 38 Battery fully charged 39 Battery low 39 Remaining battery capacity 40 Travel lock 40 Charging 41 Charging in the charger 41 Charging in the Jet Clean System (RQ1195 only) 42 Using the shaver 42 Shaving 42 Using the trimmer (RQ1155/RQ1151 only) 43 Using the Beard Styler attachment (RQ1195, RQ1175 and RQ1155/80 only) 44 Maintenance 47 Cleaning the shaving unit 47 Cleaning the shaving unit in the Jet Clean System (RQ1195 only) 48 Extra-thorough cleaning method 52 Cleaning the trimmer 54 Cleaning the Beard Styler attachment (RQ1195, RQ1175 and RQ1155/80 only) 54 Storage 54 Replacing the shaving head holder 55 Ordering accessories 56 Environment 56 Removing the rechargeable shaver battery 57 Guarantee and support 57 Guarantee restrictions 57 Troubleshooting 57 Additional information 59 34 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 5 Reattach the shaving head holder to the bottom part of the shaving unit (‘click’). Cleaning the shaving unit in the Jet Clean System (RQ1195 only) The Jet Clean System has an automatic cleaning program. When you press the on/off button, the Jet Clean System starts cleaning in this automatic cleaning program. Preparing the Jet Clean System for use Fill the cleaning chamber before first use. 1 Put the small plug in the Jet Clean System. , , The holder automatically moves to the highest position. 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). , , The cleaning chamber remains behind. English 49 4 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. 5 Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. This guarantees an optimal lifetime for the cleaning fluid. 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). 3 Press the on/off button on the Jet Clean System to start the cleaning program. , , The shaver display stops showing the charging indication. 50 English , , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , , The cleaning light flashes throughout the cleaning program, which takes a few minutes. [. . . ] RQ1195 only: The shaver is not entirely clean after I clean it in the Jet Clean System. Press the on/off button for 3 seconds to deactivate the travel lock. The shaving head holder is Clean the shaving head holder or soiled or damaged to such an replace it (see chapters ‘Cleaning extent that the motor cannot and maintenance’ and ‘Replacerun. € The temperature of the shaver Let the shaver cool down. [. . . ]