User manual PHILIPS RQ1250CC

[. . . ] Always here to help you Register your product and get support at www. Com/welcome RQ1200 series User manual 1 ENGLISH 4 DEUTSCH 28 ΕΛΛΗΝΙΚΑ 52 SUOMI 77 FRANÇAIS 101 DANSK 126 NEDERLANDS 150 ESPAÑOL 175 ITALIANO 199 NORSK 223 PORTUGUÊS 247 SVENSKA 272 TÜRKÇE 296 RQ1200 series 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] -- Type RQ1007 has one automatic cleaning program. When you press the on/off button, the Jet Clean System starts cleaning in the automatic cleaning program. € Preparing the Jet Clean System for use Fill the cleaning chamber before first use. 1 Put the small plug in the Jet Clean System. , , The holder automatically moves to the highest position. ENGLISH 17 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). , , The cleaning chamber remains behind. 4 Unscrew the cap from the bottle with HQ200 cleaning fluid. € 5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. 6 Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. This guarantees an optimal lifetime for the cleaning fluid. 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). 3 RQ1008: Press the up/down button to select a cleaning program. 18 18 ENGLISH 4 Press the on/off button on the Jet Clean System to start the cleaning program. , , The shaver display stops showing the charging indication. , , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , , The cleaning light flashes throughout the cleaning program, which takes a few minutes. [. . . ] The Jet Clean System does not work when I press the on/off button. The Jet Clean System is not connected to the mains. Refill the cleaning chamber with cleaning fluid to a level between the two lines (see chapter ‘Cleaning and maintenance’). only use HQ200 Philips Cleaning Fluid. [. . . ]