User manual PHILIPS RQ-1260 QUICK START GUIDE

[. . . ] Danger - Make sure the adapter does not get wet. Always check if the water is not too hot, to prevent your hands from getting burnt. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. - These appliances are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. [. . . ] Press the shaver tightly into the holder to lock it into place. Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit. , The display shows that the shaver is charging (see chapter `The display'). Using the shaver shaving 1 Press the on/off button once to switch on the shaver. , The display lights up for a few seconds. 2 Move the shaving heads over your skin. Make both straight and circular movements. - Shaving on a dry face gives the best results. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Press the on/off button once to switch off the shaver. , The display lights up for a few seconds and then shows the remaining battery capacity (RQ1090/ RQ1060 only). Using the Jet clean system 1 Place the shaver in the holder. , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , The cleaning light flashes throughout the cleaning program, which takes to 6 minutes, depending on the cleaning program. , During the first phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down. , During the second phase of the cleaning program , the shaver is placed in the drying position , indicated by a flashing drying symbol. The shaver stays in this position until the end of the program. , After the cleaning program , the charging indication appears on the shaver display (see chapter `The display'). Note: If you press the on/off button of the Jet Clean System during the cleaning program, the program aborts and resets. In this case, the cleaning or drying light stops flashing and the holder returns to its starting position. Note: If you remove the adapter from the wall socket during the cleaning program, the program aborts. the holder remains in its current position. [. . . ] 2 Insert the lug of the new shaving unit into the slot in the top of the shaver (1). Then press the shaving unit downwards (2) to attach it to the shaver (`click'). Ordering parts The following parts are available: - HQ8500 adapter - RQ10 Philips arcitec Shaving Unit - HQ110 Philips Shaving Head Cleaning Spray - HQ200 Philips Cleaning Fluid Environment - Do not throw away the appliances with the normal household waste at the end of their life, but hand them in at an official collection point for recycling. By doing this, you help to preserve the environment. [. . . ]