User manual PHILIPS S9021/12

[. . . ] S91xx/S90xx 1 1 2 3 1 2 3 1 2 3 4 5 1 2 3 4 2 3 4 1 2 3 4 5 1 2 Basic Plus 3 3 4 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 9 10 ENGLISH 12 DANSK 38 ΕΛΛΗΝΙΚΑ 65 SUOMI 98 NORSK 124 SVENSKA 150 S91XX, S90XX 12 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. Save this user manual for future reference. [. . . ] Using the beard styler attachment with comb You can use the beard styler attachment with the comb attached to style your beard at one fixed setting, but also at different length settings. The hair length settings on the beard styler attachment correspond to the remaining hair length after cutting and range from 1 to 5mm. 1 Slide the comb straight into the guiding grooves on both sides of the beard styler attachment (‘click’). 2 Press the length selector and then push it to the left or right to select the desired hair length setting. 3 Press the on/off button once to switch on the appliance. 4 You can now start styling your beard. ENGLISH 23 Using the beard styler attachment without comb You can use the beard styler attachment without the comb to contour your beard, moustache, sideburns or neckline. 1 Pull the comb off the beard styler attachment. Note: Grab the comb in the centre to pull it off the beard styler attachment. 2 Press the on/off button once to switch on the appliance. 3 You can now start contouring your beard, moustache, sideburns or neckline. Cleaning and maintenance Cleaning the shaver in the SmartClean system The SmartClean system comes in two types: -- SmartClean system Basic has one phase: the rinsing phase. -- SmartClean system Plus has two phases: the rinsing phase and the drying phase. 24 ENGLISH Preparing the SmartClean system for use Do not tilt the SmartClean to prevent leakage. Note: Hold the SmartClean while you prepare it for use. 1 Put the small plug in the back of the SmartClean system. 3 Press the button on the side of the SmartClean system (1) and lift the top part of the SmartClean system (2). 4 Pull the seal off the cleaning cartridge. 5 Place the cleaning cartridge in the SmartClean system. 6 Push the top part of the SmartClean system back down (‘click’). ENGLISH 25 Using the SmartClean system Always make sure to shake excess water off the shaver before you place it in the SmartClean. 1 Hold the shaver upside down above the holder. [. . . ] Water is leaking from the bottom of the shaver. The SmartClean system does not work when I press the on/off button. During cleaning, water may collect between the inner body and the outer shell of the shaver. The SmartClean system is not connected to the mains. [. . . ]