User manual PHILIPS SBC RU880

[. . . ] INTRODUCTION You have made a great choice by buying this Philips universal remote control!It replaces up to eight separate remote controls and is pre-programmed to operate with almost any brand of TV, VCR, satellite tuner, cable decoder, CD-player, DVDplayer, tuner and amplifier. the SBC RU880 can also control Philips Power Control System devices. It can even learn the codes of other remote control units that are not pre-programmed. [. . . ] 5 SETTING UP AN EXTRA DEVICE ON THE SBC RU880 The SBC RU880 has eight operating modes for operating eight different devices. It can also be programmed for any combination of devices contained in its library. the HOME mode on the SBC RU880 is factory pre-set to control the Philips Power Control System (see 5. `Setting up the SBC RU880 for your Philips Power Control System'), but you can change it to control, for example, a second TV. Before you start, make sure the SBC RU880 is in the HOME mode. Also, make sure the equipment is switched on, and that you're sitting right in front of it. 1 If you know the brand name If you know the brand name of your second TV look at the code list at the back of this book to find the first 3-digit code for this TV. Then: 1 Press and hold the SMART key (for about three seconds) until the LCD displays TIMER. ­ If the code is correct, the display indicates OK for one second and returns to normal operation. When you press the TV MODE key the LCD displays TV1. Now press a few keys on the SBC RU880 to check that the equipment responds correctly. If it doesn't, try again from step 1 using the next code in the list. If none of the codes work properly, follow the instructions in the next section. Tip: Make a note of the code inside the battery case and in the back of this booklet in case you ever need to set up again. 2 If you don't know the brand name If you don't know the brand name of your equipment or if you cannot find it in the code list, set-up still won't take long. You will know the correct code has been found when the equipment switches off. Then: 1 Press the SMART key (for about three seconds) until the LCD displays TIMER. 5 second period between each transmission. When the right code is found, the TV switches off. ­ The LCD displays OK for a second and then returns to normal operation. 1 COPYING THE FUNCTIONS OF KEYS 1 Press and hold the SMART key (for about three seconds) until the LCD displays TIMER. ­ The SBC RU880 is now ready to move keys and the LCD displays FROM. [. . . ] the house code's default setting is A. To change the house code: Verify that the house code already is installed. Look at the house code selection wheel at the rear of the switches (A-P). If you want to change the house code turn this wheel with a screwdriver. [. . . ]