User manual PHILIPS SBCBA140

[. . . ] Battery or mains operated Speaker can be powered by batteries or mains Multiple speakers with one transmitter An additional number of wireless speakers can be used with a single transmitter if they: - operate in the 864 MHz band - can detect a 19 kHz pilot tone Please consult the appliance's electrical specification sheets for confirmation on compatibility. Speaker (figure 1) 1 Charge indication LED ­ lights up when batteries are being charged. 2 Power indication LED ­ lights up when speaker is switched on. 3 Power On/Off ­ push the button to switch the speaker on/off. [. . . ] 8 DC power ­ connect to the 9 Volt/ 500 mA AC/DC adapter 9 L/ L+R/ R switch ­ switch the L/ L+R /R switch to L+R when only using one speaker. Switch to L or R for left or right use when using two speakers. This FM speaker system consists of the following accessories: 1 x SBC BC8210 FM speaker 1 x SBC BC211/00 9 Volt/500 mA AC/DC adapter 6 x rechargeable batteries LR6/AA (NiCd), 700 mAh IMPORTANT Use only Philips SBC CS030/00 12 Volt/ 200 mA AC/DC adapter 1 Make use of the Philips SBC HC 8372 FM wireless transmitter. This transmitter can be purchased separately. ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. 3 When the sound quality of the FM speaker degrades, it indicates that the batteries are running low. Notes: Completely flat batteries need approximately 16 hours to recharge. Always remove the batteries if the speaker is not to be used for a long period of time. Do not use alkaline batteries as these may damage your FM wireless system!We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene Your unit consists of materials which can be recycled if disassembled by a specialized company. Do not use alkaline batteries as these may damage your FM wireless system!(See Speaker power supply) ­ Check if the audio source is switched on and tuned to a channel with audio. Turn the tuning wheel until the signal is at its clearest. Some transmitters already built into other equipment may not be compatible with the BC8210 speaker because of the advanced technologies used in the BC8210 speaker. Adjust the speaker's tuning frequency. Turn the tuning wheel until the signal is at its clearest. (See Speaker power supply) ­ Check the volume on audio source/ speaker is not set at too high a level. English 10 Distorted sound ­ Distance from the transmitter is too large. ­ Interference from fluorescent lamps/ other radio sources. Some transmitters already built into other equipment may not be compatible with the BC8210 speaker because of the advanced technologies used in the BC8210 speaker. ­ If the speaker will not be used for a longer time, please remove the batteries to prevent leakage and corrosion. Only replace the batteries with LR6/AA NiCd batteries (preferably Philips). [. . . ] Only replace the batteries with LR6/AA NiCd batteries (preferably Philips). ­ Do not leave the speaker near heat sources. Do not expose to direct sunlight, excessive dust, moisture, rain or any kind of mechanical shock. ­ Do not use alcohol, thinner or petroleum-based substances to clean the speaker or transmitter. [. . . ]