User manual PHILIPS SBCBM140

[. . . ] Check if the voltage indicated on the type plate of the adapter corresponds to the local mains voltage before connecting to the mains power supply. Remove the batteries from the headphone's battery compartment and disconnect the adapter from the mains if the system is not in use for a long period of time. Prevent fire or shock hazard: do not expose this equipment to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. IMPORTANT Before using the IR headphone for the first time, please ensure that the batteries are fully charged for about 16 hours. [. . . ] The immersive surround sound technology in the SBC HC 210 headphone transforms a stereo signal into a natural, three-dimensional experience ­ without the need for loudspeakers all around the room. Auto mute for noise free operation reduces the noise disturbance when the sound signal is too low or not available. Neodymium speaker drivers for faster bass response and lower overall distortion. 4 Power switch ­ power on/off switch 5 Recharging output ­ connect the recharge cable to the output 6 DC power ­ connect to the 12 Volt/ 200 mA AC/DC adapter 7 3. 5 mm stereo headphone audio input ­ connects your IR transmitter to an audio source Headphone (figure 2) 8 IR sensors ­ to receive IR waves from the transmitter 9 Power indication ­ lights up when in use 10 Power On/Off ­ slide the switch to the on or off position to switch the headphone on/off 11 Recharging indicator ­ lights up when the recharging cable is connected between the headphone and the IR transmitter. Completely empty batteries will be fully charged after about 16 hours 12 Recharging input (figure 3) ­ switch off the headphone prior to connecting the recharging cable to the transmitter. The recharging indicator on the headphone must light up, indicating that the headphone is being recharged 13 Volume ­ adjust volume to your desired listening level English 3 Power indication ­ lights up when in use This IR headphone system consists of the following accessories: 1 x SBC HC212 IR transmitter 1 x SBC HC215 IR headphone 1 x SBC CS030/00 12 Volt/200 mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/200 mA AC/DC adapter) 2 x Philips SBC HB550S rechargeable R03/AAA (NiMH) batteries 1 x 3. 3 mm stereo adapter plug 1 recharge cable Transmitter (figure 1) 1 IR transmitting LEDs ­ transmit audio signal to IR headphone 2 SRS Headphone surround sound button ­ push the button to switch on the SRS Headphone surround sound (the SRS Headphone logo will light up when activated) ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. Note: Completely empty batteries need approximately 16 hours to recharge. Always remove the batteries if the headphone is not to be used for a long period of time. 2 Take out the batteries and dispose of them properly. IMPORTANT: in case of certain TVs the headphone output level can only be adjusted after accessing the TV on-screen menu. Some transmitters already built into other equipment may not be compatible with the HC215 headphone because of the advanced technologies used in the HC215 headphone. (See Headphone power supply) ­ Check the volume on audio source/ headphone is not set at too high a level. IMPORTANT: in case of certain TVs the headphone output level can only be adjusted after accessing the TV on-screen menu. ­ Distance from the transmitter is too large. ­ Interference from fluorescent lamps/ other light sources. Some transmitters already built into other equipment may not be compatible with the HC215 headphone because of the advanced technologies used in the HC215 headphone. ­ If the headphone will not be used for a longer time, please remove the batteries to prevent leakage and corrosion. Only replace the batteries with Philips SBC HB550S batteries. ­ Do not leave the headphone near heat sources. Do not expose to direct sunlight, excessive dust, moisture, rain or any kind of mechanical shock. [. . . ] Use a slightly dampened chamois cloth to clean the housing. ­ Do not use cleaning agents containing alcohol, spirits, ammonia or abrasives as these may harm the housing. Continuous use at a high volume may permanently damage your hearing. system: Modulation: Effective Transmission Range: Input level: Power supply ­ transmitter: Power supply ­ headphone: Carrier Frequency (Headphone): Signal/Noise ratio: Distortion: Channel separation: Infra Red (IR) Frequency Modulation (FM) 7 meters max. [. . . ]