User manual PHILIPS SBCHC550

[. . . ] When no audio signals are detected the FM transmitter automatically switches off after a few minutes. The green LED lights up during charging. Easy transmission The FM headphone is able to receive signals from the transmitter, even through barriers such as doors, walls and windows. Multiple headphones with one transmitter An additional number of headphones and/or wireless speakers can be used with a single transmitter if they: - operate in the 864 MHz band - can detect a 19 kHz pilot tone Please consult the appliance's electrical specification sheets for confirmation on compatibility. [. . . ] 3 Recharging indicator ­ lights up when the recharge cable is connected between the headphone and the FM transmitter. Completely flat batteries will be fully charged after about16 hours. We advise you to select channel 1 as a first option. This FM headphone system consists of the following accessories: 1 x SBC HC8802 FM transmitter 1 x SBC HC8805 FM headphone 1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter) 2 x rechargeable batteries LR03/AAA (NiMH), 550 mAh 1 x 3. English Headphone (figure 2) 9 Power On/Off ­ push the button to switch the headphone on/off. 10 Power indication ­ lights up when in use. When batteries are low, the power indicator flashes, and you should recharge the headphone for about 16 hours before the next use. 11 Recharging indicator ­ lights up when the recharge cable is connected between the headphone and the FM transmitter. Completely flat batteries will be fully charged after about 16 hours. 12 Recharging input ­ connect the recharge cable to the input, green recharging LED on the transmitter's front must switch on, indicating that the headphone is being recharged. 14 Volume ­ adjust volume to your desired listening level. The red power indication LED of the transmitter lights up if receiving an audio signal. You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter. If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty. ­ Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly inserted into the 12 Volt DC input connector located at the rear of the transmitter. (See Headphone power supply) ­ Check if the audio source is switched on and tuned to a channel with audio. Some transmitters already built into other equipment may not be compatible with the HC8805 headphone because of the advanced technologies used in the HC8805 headphone. Next adjust the headphone's frequency by pressing and holding the tuning button for about 1 second. English 10 Distorted sound ­ Check if the volume on audio source/ headphone is not set at too high a level. ­ Distance from the transmitter is too large. [. . . ] ­ Interference from fluorescent lamps/ other radio sources. Some transmitters already built into other equipment may not be compatible with the HC8805 headphone because of the advanced technologies used in the HC8805 headphone. ­ If the headphone will not be used for a long time, please remove the batteries to prevent leakage and corrosion. Only replace the batteries with LR03/AAA NiMH batteries (preferably Philips). [. . . ]