User manual PHILIPS SBCHC600

[. . . ] without the inconvenience of cables or headphone wires!To ensure you get the best performance from your IR cordless stereo sound system please read this manual carefully. Range, depending on ambient conditions and restricted to line of sight with relation to the transmitter. All the safety and operating instructions should be read before using the wireless headphone system. [. . . ] Check if the voltage indicated on the type plate of the adapter corresponds to the local mains voltage before connecting to the mains power supply. Remove the batteries from the headphone's battery compartment and disconnect the adapter from the mains if the system is not in use for a long period. Prevent fire or shock hazard: do not expose this equipment to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. This IR headphone system consists of the following accessories: 1 x SBC HC132 IR transmitter 1 x SBC HC135 IR headphone 1 x SBC CS030/00 12 Volt/200 mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter) 2 x non-rechargeable batteries R03/AAA (ZnCl) 1 x 3. 7 Power indication ­ lights up when in use. 8 Power On/Off ­ slide the switch to the on or off position to switch the headphone on/off. 9 Volume ­ adjust volume to your desired listening level. (For UK, use only Philips SBC CS030/05) 1 Make sure the adapter's rated voltage corresponds to the mains socket voltage. ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty. ­ Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly inserted into the 12 Volt DC input connector located at the rear of the transmitter. Some transmitters already built into other equipment may not be compatible with the HC135 headphone because of the advanced technologies used in the HC135 headphone. ⭠Headphone batteries running low. (See Headphone power supply) ­ Check the volume on audio source/ headphone is not set at too high a level. ­ Distance from the transmitter is too large. ­ Interference from fluorescent lamps/ other radio sources. Some transmitters already built into other equipment may not be compatible with the HC135 headphone because of the advanced technologies used in the HC135 headphone. ­ If the headphone will not be used for a longer time, please remove the batteries to prevent leakage and corrosion. [. . . ] Some transmitters already built into other equipment may not be compatible with the HC135 headphone because of the advanced technologies used in the HC135 headphone. ­ If the headphone will not be used for a longer time, please remove the batteries to prevent leakage and corrosion. ­ Do not leave the headphone near heat sources. Do not expose to direct sunlight, excessive dust, moisture, rain or any kind of mechanical shock. [. . . ]