User manual PHILIPS SBCHC620

[. . . ] Automatic power on/off indicator The FM transmitter automatically switches on and starts transmitting when audio signals are detected at the audio input (red LED). When no audio signals are detected the FM transmitter automatically switches off after a few minutes. The green LED lights up during charging. Easy transmission The FM headphone is able to receive signals from the transmitter, even through barriers such as doors, walls and windows. [. . . ] English Headphone (figure 2) 9 Power indication ­ lights up when in use. When batteries are low, the power indicator flashes, and you should recharge the headphone for about 16 hours before the next use. 10 Power On/Off ­ push the button to switch the headphone on/off. 11 Recharging contacts ­ align headphone to the transmitter, green recharging LED on the transmitter's front must switch on, indicating that the headphone is being recharged. 12 Volume ­ adjust volume to your desired listening level. 13 SRSTM On/Off ­ push the button to switch the SRSTM surround sound mode on/off. 14 SRSTM indication ­ lights up when the SRSTM surround sound mode is activated. 16 Tuning indicator ­ lights up when receiving optimal transmission. (For UK, use only Philips SBC CS030/05) 1 Make sure the adapter's rated voltage corresponds to the mains socket voltage. ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. Do not use NiCd batteries or alkaline batteries as these may damage your FM wireless system!­ Check if the white RCA plug (left channel) is connected to the left channel (white) of the FM transmitter's audio input 2. 3 Switch on your audio source and carefully increase the volume of the audio source. The red power indication LED of the transmitter lights up if receiving an audio signal. You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter. Repeat if necessary until the red tuning indication lights up. 1 Switch on your audio source and carefully increase the volume of the audio source. The red power indication LED of the transmitter lights up if receiving an audio signal. You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter. 3 To tune , press and hold the tuning control button for about 1 second. Repeat if necessary until the red tuning indication lights up. If a fault occurs, first check the points listed below before taking the set for repair. [. . . ] ­ The SRSTM surround sound mode works best on normal stereo signals. Make sure that the surround modes on the audio source are switched off when listening to the HC8855 headphone. ­ If the headphone will not be used for a long time, please remove the batteries to prevent leakage and corrosion. ⭠Only replace the batteries with R03/AAA NiMH batteries (preferably Philips). [. . . ]