User manual PHILIPS SBCHC710

[. . . ] The green LED lights up during charging. Easy transmission The FM headphone is able to receive signals from the transmitter, even through barriers such as doors, walls and windows. Multiple headphones with one transmitter An additional number of headphones and/or wireless speakers can be used with a single transmitter if they: - operate in the 864 MHz band - can detect a 19 kHz pilot tone. Transmitter (figure 1) 1 Power indicator ­ lights up when audio signals are detected at the audio input. [. . . ] The green LED lights up during recharging. We advise you to select channel 1 as a first option. 7 Controls plate Headphone (figure 2) 8 Power indication ­ lights up when in use. 9 Power On/Off ­ slide the switch to the on or off position to switch the headphone on/off. 10 Battery compartment ­ open the lid, take out the batteries and put them in the transmitter's recharging compartment for recharging. 11 Volume ­ adjust volume to your desired listening level. 12 Tuning ­ turn the tuning knob until the signal is at its clearest. This FM headphone system consists of the following accessories: 1 x SBC HC8392 FM transmitter 1 x SBC HC8395 FM headphone 1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter) 2 x rechargeable batteries LR03/AAA (NiMH), 550 mAh 1 x 3. (For UK, use only Philips SBC CS030/05) 1 Make sure the adapter's rated voltage corresponds to the mains socket voltage. ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. 4 Insert the antenna tube in the hole , located on the top of the transmitter. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty. ­ Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly inserted into the 12 Volt DC input connector located at the rear of the transmitter. Take out the batteries and put them in the transmitter's recharging compartment for recharging. (See Headphone power supply) ­ Check if the audio source is switched on and tuned to a channel with audio. Turn the tuning knob until the signal is at its clearest. Some transmitters already built into other equipment may not be compatible with the HC8395 headphone because of the advanced technologies used in the HC8395 headphone. Adjust the headphone's tuning frequency. Turn the tuning knob until the signal is at its clearest. Next adjust the headphone's frequency by turning the tuning knob until the signal is at its clearest. Take out the batteries and put them in the transmitter's recharging compartment for recharging. Distorted sound ­ Check the volume on audio source/ headphone is not set at too high a level. [. . . ] ­ Interference from fluorescent lamps/ other radio sources. Some transmitters already built into other equipment may not be compatible with the HC8395 headphone because of the advanced technologies used in the HC8395 headphone. ­ If the headphone will not be used for a long time, please remove the batteries to prevent leakage and corrosion. Only replace the batteries with LR03/AAA NiMH batteries (preferably Philips). [. . . ]