User manual PHILIPS SBCHC8410

[. . . ] Easy transmission The FM headphone is able to receive signals from the transmitter, even through barriers such as doors, walls and windows. Multiple headphones with one transmitter An additional number of headphones and/or wireless speakers can be used with a single transmitter if they: - operate in the 864 MHz band - can detect a 19 kHz pilot tone. Transmitter (figure 1) 1 Power indicator ­ lights up when audio signals are detected at the audio input. We advise you to select channel 1 as a first option. [. . . ] We advise you to select channel 1 as a first option. 5 Controls plate Headphone (figure 2) 6 Power On/Off ­ slide the switch to the on or off position to switch the headphone on/off. 7 Battery compartment ­ open the lid, take out the batteries and replace them when empty. 8 Volume ­ adjust volume to your desired listening level. 9 Tuning ­ turn the tuning wheel until the signal is at its clearest. 10 Power indication ­ lights up when in use. This FM headphone system consists of the following accessories: 1 x SBC HC8332 FM transmitter 1 x SBC HC8305 FM headphone 1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter) 2 x non-rechargeable batteries LR03/AAA (ZnCl) 1 x 3. (For UK, use only Philips SBC CS030/05) 1 Make sure the adapter's rated voltage corresponds to the mains socket voltage. ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. 4 Insert the antenna tube in the hole , located on the top of the transmitter. 1 Switch on your audio source and carefully increase the volume of the audio source. The red power indication LED of the transmitter lights up if receiving an audio signal. You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter. 3 To tune, turn the tuning wheel until the signal is at its clearest and the tuning indicator will light up. English 8 If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty. ­ Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly inserted into the 12 Volt DC input connector located at the rear of the transmitter. Take out the batteries and replace them with fresh batteries. (See Headphone power supply) ­ Check if the audio source is switched on and tuned to a channel with audio. [. . . ] ­ Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly inserted into the 12 Volt DC input connector located at the rear of the transmitter. Take out the batteries and replace them with fresh batteries. (See Headphone power supply) ­ Check if the audio source is switched on and tuned to a channel with audio. Turn the tuning wheel until the signal is at its clearest. [. . . ]