User manual PHILIPS SBCHD1505U

[. . . ] Dolby Headphone is a revolutionary signal processing system that works not only with multi channel audio but also with conventional stereo signals. In case of multi channel audio signals, Dolby Headphone technology will process these signals in such a way that you will experience the sound through your headphone as if it were coming from an actual five-speaker home entertainment set-up. And even when listening to conventional stereo signals, Dolby Headphone will give you a much more natural and less fatiguing listening experience, equivalent to a good two-speaker playback system in a room with good acoustics. Dolby Headphone technology can model the sound of a playback system in up to three different listening environments, based on acoustic measurements of real rooms: · DH1 is a small, well-damped room appropriate for both movies and music-only recordings. [. . . ] B) Inserting batteries into the headphone 1 Make sure that the power button of the headphone is in position `off '. 2 Open the headphone's battery compartment door located on the RIGHT earshell. 3 Insert battery pack, and make sure it is correctly positioned as indicated by the engraved symbols. Use only the original rechargeable battery pack (SBC EH2412/00) that came with the HD1505U headphone. Do not use other NiMH batteries, NiCd batteries or alkaline batteries as these may damage your Digital wireless system! Completely flat batteries need approximately 16 hours to recharge. The charging process is of the so-called `low-rate' class, resulting in increased life span of batteries. The battery pack cannot be overcharged, as soon as the batteries are fully charged, the charging circuitry switches to `trickle charge' in order to keep the batteries in excellent condition. Always remove the battery pack from the headphone if the headphone is not to be used for a long period of time. The battery pack slowly loses its charge when not used for a longer period of time, even when left outside the battery compartment. To prevent battery leakage which may result in bodily injury, property damage or damage to the unit, install ALL batteries correctly, + and - as marked on the unit. In case the headphone does not tune properly to the transmitter, then press the tuning button. These functions only work with corded headphones. ­ Power status is indicated by SYSTEM STATUS light 2 TUNE Automatic transmission channel search by pushing the button 3 SYSTEM STATUS indicator The SYSTEM STATUS indicator on the control panel will indicate the status of the headphone by means of different colors and different blinking modes. Some of these modes also have an audible alarm. You have a limited time to replace batteries before the headphone will go in power save mode RED blinking (2 secs) + short GREEN burst + all other indicators on the headphone are off - Power save mode The power save mode is initiated when there is no valid radio signal available or after digital silence for 1 minute. In the `power save mode', the headphone is in fact still operational but not continuously. It will restart every 2 seconds to look if in the meantime it can receive a valid radio signal. [. . . ] Following this Directive, this product can be brought into service in the following states: SBC HD1505U/00 R&TTE Directive 1999/5/EC This product complies with class 2 requirements as set down in EN 301 489-9. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. please inform yourself about the local separate collection system for electrical and electronic products. [. . . ]