User manual PHILIPS SBCHN060

[. . . ] This system uses the latest FM wireless technology, which gives you complete freedom of movement while enjoying your favorite music and movies. No more inconvenience from cables or transmitter wires!To ensure you get the best performance from your FM wireless stereo sound system please read this manual carefully. [. . . ] Check if the voltage indicated on the type plate of the adapter corresponds to the local mains voltage before connecting to the mains power supply. Remove the batteries from the headphone's battery compartment and disconnect the adapter from the mains if the system is not in use for a long period. Prevent fire or shock hazard: do not expose this equipment to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. Radio equipment for wireless audio applications is not protected against disturbance from other radio services. This FM transmitter system consists of the following accessories: 1 x SBC HC8372 FM transmitter 1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter) 1 x 3. (For UK, use only Philips SBC CS030/05) 1 Make sure the adapter's rated voltage corresponds to the mains socket voltage. ­ Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time. 4 Insert the antenna tube in the hole , located on the top of the transmitter. Ensure that the wire which is hanging out of that hole, is guided in the antenna tube. If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty. ­ Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly inserted into the 12 Volt DC input connector located at the rear of the transmitter. We advise you to select channel 1 as a first option. ­ Distance from the transmitter is too large. ­ Interference from fluorescent lamps/ other radio sources. move transmitter elsewhere/ change the transmitter's channel. ­ Do not leave the transmitter near heat sources. [. . . ] ­ Do not leave the transmitter near heat sources. Do not expose to direct sunlight, excessive dust, moisture, rain or any kind of mechanical shock. ­ Do not use alcohol, thinner or petroleum-based substances to clean the transmitter. [. . . ]