User manual PHILIPS SBCLI900

[. . . ] The RF Extender receives radio frequency (RF) signals sent out by the Pronto and converts them into infrared (IR) signals. These IR signals are then sent out to your TV, DVD, preamplifier and so on. The following components should be present: RF Extender, power adapter, 4 dual IR emitters, mounting plate and 4 screws. Before you install the RF Extender, you should decide which of the set-ups described on p. [. . . ] You can use the dual IR emitters as an alternative for the IR blaster. When to use the emitters The IR emitters can control devices the IR blaster cannot reach, for instance when there is limited space around the receiving eyes of the devices, e. Note The IR emitters can also be used in combination with the IR blaster of the RF Extender. Both send out IR signals simultaneously. This allows you to operate several devices using both the IR blaster and the IR emitters. When connecting the power adapter it is recommended that you plug the adapter into the RF Extender before you plug it into the socket. When connected you will see a red LED on the RF Extender. To avoid interference, the adapter cable should be kept away from the RF Extender as far as possible. How to use the emitters The dual IR emitters can be attached to the surrounding surface facing the receiving eyes or directly to the receiving eyes. 1 Attach the emitters to a surface above, below or in front of the receiving eyes of your devices (for aesthetic appearance or when it is difficult to locate the receiving eye). ­ or ­ Attach the emitters directly to the receiving eyes of your devices. As the RF Extender `communicates' with the Pronto Remote Control, you have to set the same Extender ID (identity) on both appliances. The settings depend on whether you have a single RF Extender or multiple RF Extenders. Single RF Extender When you use only one RF Extender, you can accept the default setting for the Extender ID (ID=0). Make sure your Pronto Remote Control is set to the same default setting (see the Pronto User Guide for more details). Multiple RF Extenders If you want to operate several of your devices independently, e. Grouped on different locations, you will need multiple RF Extenders. When using several RF Extenders, it is important to assign a unique Extender ID to each RF Extender. 16 Extender IDs (from 0 to 9 and from A to F) can be assigned. 1 Choose an Extender ID for the RF Extender by turning the ID dial with a small screwdriver. 2 On the Pronto Remote Control, choose the same Extender ID for each device controlled by the RF Extender. refer to the Pronto User Guide for more information. [. . . ] In that case you will have to reconfigure the Pronto Remote Control to operate your devices with IR signals again. Another device in the proximity is sending out RF signals. The dual IR emitters are no longer adhesive · Replace the adhesive with a fresh piece of the 2-sided tape. I cannot find the exact location of the device's receiving eye · check the manual of the device. [. . . ]