User manual PHILIPS SBCRU120

[. . . ] ⷠDon't leave the batteries out for longer than one hour, otherwise you will need to set-up the SBC RU120 again. In case you have to program the SBC RU120 for use with your device you have to enter a 6-digit code (e. These are the digits that these buttons represent: = digit 0, = digit 1, - = digit 2, = digit 3. - Not all brands have this shifted functionality so it could be possible that this feature does not work on your equipment. [. . . ] Make sure that you keep the remote control pointed at your equipment. ­ Each time the green LED flashes, another code is sent. When the right code is found, the equipment switches off. If you accidentally press the power key again, after the equipment switched off, you miss the correct code!If you accidentally skipped the code follow the next procedure starting at step 4. If you did not skip the code go to step 7. 6 Press the power key repeatedly until the equipment 7 Press the mute key to lock the correct code in the SBC Press a few keys to check correct response. If response is not correct, repeat procedure beginning at step 1. - The search time averages about 90 seconds. - If the LED blinks twice, after you pressed the power key (step 3), this means you have tried all codes. If non of the codes worked, try the Autosearch procedure again, starting at step 1. Even when your TV can be activated by using a digit key only (e. Digit number 1) instead of using the power key, you need to install the "Power/Digit Toggle" function. After you installed this function, the power key will send out the "power on/off" code, the first time you press the "power" key and the "digit 1" code when you press the "power" key for the second time. In this way it is possible to activate your TV even when it responds to digit codes only. To install this "Power/Digit Toggle" function, follow the following procedure: 1 Look up the "Power/Digit toggle" code in the code list (centre of this manual). 2 Press and hold power and mute keys simultaneously ­ for about three seconds ­ until the green LED lights up. (Release the keys: the green LED should stay on). Equipment is not responding and the green light does not flash when you press a button. ­ Replace batteries with two new 1. [. . . ] If you don't find an answer to your questions, make a note of your equipment in the table at the back of the code list section of this booklet. This makes it easier and faster for our operators to help you. Look for the model number in the equipment instruction manual, or on the back of your equipment. When calling our help-line please have your equipment close by, so our operators can help you verify the functionality of your remote control. [. . . ]