User manual PHILIPS SBCRU258

[. . . ] Place two R03, UM4 or AAA type batteries into the battery compartment, as shown. Slide the cover back and click it firmly into place. Because the RU258 may use different signals for each make and even for different models of the same make, it is advisable to test whether your appliance responds to the RU258. The example below (TV) instructs you how to do this. [. . . ] 2 Look up the brand of your TV in the code list at the back of this manual. One or more three-figure codes are shown for each brand. Make sure you use the codes from the correct table. Keep keys `1' and `3' pressed simultaneously for three seconds until the green indicator light remains lit. Then enter the code noted in step 2 using the digital keys. The green indicator light will now flash twice. If the light flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the RU258 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. If you cannot find the right code for your brand device, the remote control can automatically search for the right code. Example of TV: 1 Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). The RU258 emits the `switch off TV' signal for all models of TV that are stored in the memory. 2 Then keep keys 1 and 3 on the RU258 pressed simultaneously for three seconds, until the green indicator light remains lit. The RU258 now starts emitting all known `TV off ' signals, one by one. Each time a code is sent, the green indicator light flashes. When your TV switches off (stand-by), you press the Standby key of the RU258 twice within 1 second, to confirm. The RU258 has now found a code that works on your TV. Check if you can operate all functions on your TV with the RU258. If this is not the case, you can redo the automatic setting. The RU258 will then search for a code that perhaps works better. [. . . ] - yellow teletext key - pause (VCR/DVD) 6. - blue teletext key - wind (VCR/DVD) 2 . Switches between external inputs of your equipment. The VOL ­ /VOL + and s (Mute) keys give direct access to the TV volume even if you are operating your VCR, DVD or SAT/CBL equipment. [. . . ]