User manual PHILIPS SBCRU641

[. . . ] Remember that you can't get access to additional functions if these functions were not available on the original remote control of your equipment!SLEEP: to activate and vary the sleep timer (if available on your equipment). To put subtitling on your screen (if available on your equipment), or to switch teletext off. If you use the memory out key (fi) to access the next teletext page on your Philips TV, you can use the subtitle key to access. [. . . ] 4 Press key 1 and count the number of times the green LED flashes. This is the first digit of the 4-digit code. ) 5 Press key 2 and count the number of flashes for the second digit. 6 Press key 3 and count the number of flashes for the third digit. 7 Press key 4 and count the number of flashes for the forth Carefully read the complete procedure before starting!With the mode selector it is possible to select 4 categories of devices you want to operate. Each category (TV, VCR, SAT and DVD) is meant to operate a specific group of equipment: TV tv VCR vcr SAT sat cable DVD dvd Once you have programmed the functions of a device in one of the categories, it is not possible to program another device in the same category. There is, however, a solution in case you want to program two devices in the same category (2 TV's, VCR's, etc. EXAMPLE: The SAT mode on this remote control is factory preset to control many Philips satellite receivers. You can change the SAT mode (or any mode) to operate another type of device. The following example shows you how to use the SAT mode to operate a second TV: 1 Press the mode selector key to select SAT and make sure the second TV is switched on. 2 Press and hold keys 1 and 6 simultaneously -for about 3 Seconds- until the green LED lights up. Don't forget to set up the SBC RU641 to operate this second TV. Punch-through sound enables you to control the audio level of your first or second TV, regardless of what device mode the remote control is in. eXAMPLE: You have installed a second TV under SAT mode. You can control that TV's volume when you are in VCR mode. This feature is installed as a default setting for a first TV. To install this feature for a second TV: 1 Press the mode selector key to select VCR. 2 Press and hold keys 1 and 6 simultaneously -for about 3 Seconds- until the green LED lights up. The Volume up/down keys now control the volume of your second (SAT) TV when you're in VCR mode. When you pick up the SBC RU641 and tilt it over about 60 degrees, the main keys for the device you want to operate are automatically back-lit. In VCR mode for example, only the main keys that are needed to operate the VCR are back-lit. [. . . ] If you have any questions about the SBC RU641, please call our help-line for assistance!You can find the number in the code list section of this booklet. Before you call, please read this manual carefully. You will be able to solve most of your problems. [. . . ]