User manual PHILIPS SBCSC250

[. . . ] Test food on inside of hand before serving to ensure it is at a safe temperature for your baby. use only containers that have been approved for boiling. Only use the Baby Bottle Warmer when the ambient temperature is between +7ºC and +37ºC. [. . . ] Warming the bottle without the ring, might result in a wrong temperature, therefore never use the bottle warmer without the ring. ­ The dimensions of the bottle or the material of the bottle (glass in stead of plastic) may influence selecting the correct knob setting. When you leave the bottle in the bottle warmer after it is heated up, the temperature might increase a few degrees. Fill the beaker with 20ml water by using the water cup of the ring. Place the jar in the middle of the container and put the ring on top of it. Remove the jar from the container and turn the control knob to the left to the `0' (OFF) position. 8 Stir the contents of the jar to distribute the heat. 9 Always check that the contents of the jar are at the correct temperature by testing some on the back of your hand or via your mouth. 10 If the temperature is much too low, fill the beaker again with 10ml. Turn the click-step control knob 4 to the right until the indicator lamp lights up red to start the heating up again. Warming the jar without the ring, might result in a wrong temperature, therefore never use the bottle warmer without the ring. With the Baby Bottle Warmer you can also keep the bottles and jars warm for a short time. For microbiological and hygienic reasons baby food should never be kept warm for longer than one hour. Never hold the Baby Bottle Warmer in your hands when in use. Disconnect the Baby Bottle Warmer from the mains socket and allow it to cool down. Clean the container and the outside of the Baby Bottle Warmer with a damp cloth. [. . . ] The indicator light switches on and off while keeping warm. 2 Vrid inställningsratten 4 till vänster till läget `0' (AV). 1 2 3 Vrid inställningsratten 4 till vänster till läget `0' (AV). [. . . ]