User manual PHILIPS SBCSC366

[. . . ] ­ Every time sound is detected from or near the baby, it is transmitted to the parent's unit. If it does not, consult your dealer or our service organisation. ­ If the mains power adapter is connected correctly, the red CHARGE LED on the recharging base lights up. Battery power supply (batteries not enclosed) `Baby unit' (batteries not enclosed) · `Parent unit' (batteries enclosed) ­ Rechargeable batteries are already installed inside the `parent unit'. [. . . ] Make sure that the `baby unit' is always out of reach of the baby; never place the `baby unit' inside baby's bed or playpen!­ If sound is picked up by the built-in microphone, the `baby unit' starts transmitting automatically. The transmission stops when no sound is picked up any more. During transmission the green TRANSMIT LED lights up. This function operates both during VOICE and OFF-mode. for manual transmission: · Keep the TALK button pressed and speak into the microphone. ­ Spoken sound is transmitted until the TALK button is released. ­ Do not place `baby unit' and `parent unit' too close to each other while operating. Before using the Baby phone, check the sound transmission. This checks whether a unit is broken, or whether units are placed out of range of each other. After this first check, sound transmission should be checked on a regular basis as follows: Have an adult softly speak into the `baby unit'. Sounds transmitted from the baby room should be heard clearly via the `parent unit' in another room. CHANNEL SELECTION ­ The Baby phone can use 2 different channels for radio signal transmission. If sound reception is very poor, or other radio signals are being picked up, please try the other transmission channel as follows: · Move the channel selector on both units to the other channel (fig. If the rechargeable batteries are empty they can be recharged easily via the recharging base. to recharge batteries: · Make sure that the mains power adapter is correctly connected to the recharging base. ­ If the mains power adapter is connected correctly, the red CHARGE LED on the recharging base lights up. ­ Totally empty batteries will take up 12-14 hours to fully recharge. BELT-CLIP With completely charged batteries, the `parent unit' can be used as a truly cordless product. The unit can be carried in and around the house, using the easy belt-clip. [. . . ] Notes: ­ Talking back via the `parent-unit' is only possible if the `parent-unit' is not receiving a signal!­ The `baby unit' only receives a signal if it is not already transmitting sounds. 9) again after using talk-back possibility. Anslut en av de medföljande nätadaptrarna till babyns enhet och den andra till laddningsbasen på föräldrarnas enhet (fig. [. . . ]