User manual PHILIPS SBCSC368/13C

[. . . ] ­ Every time sound is detected from or near the baby, it is transmitted to the parent's unit. If it does not, consult your dealer or our service organisation. ­ If the mains power adapter is connected correctly, the red CHARGE LED on the recharging base lights up. Battery power supply Transmitter (batteries not enclosed) · Receiver (batteries enclosed) ­ Rechargeable battery pack is already installed inside the receiver. [. . . ] Place the receiver inside the recharging base, near to the parent's location. ­ If the mains power adapter is connected correctly, the red CHARGE LED on the recharging base lights up. ­ If a sound signal is received from the `baby unit', it is heard via the built-in speaker. Make sure that the transmitter is always out of reach of the baby; never place the transmitter inside baby's bed or playpen!­ If sound is picked up by the built-in microphone, the transmitter starts transmitting automatically. The transmission stops when no sound is picked up any more. During transmission the green TRANSMIT LED lights up. The Babysitter sound level can be adjusted by turning the SENSITIVITY control (fig. ­ The higher the sensitivity is set, the earlier the unit starts transmitting when your baby makes a sound. Notes Do not place transmitter and receiver too close to each other while operating. Before using the Babysitter, check the sound transmission to ensure that both units function correctly. After this first check, sound transmission should be checked on a regular basis as follows: ­ Sounds transmitted from the baby room should be heard clearly via the receiver in another room. CHANNEL SELECTION ­ The Babysitter can use 2 different channels for radio signal transmission. If sound reception is very poor, please try the other transmission channel as follows: · Move the channel selector on both units to the other channel (fig. If the rechargeable batteries are empty they can be recharged easily via the recharging base. to recharge batteries: · Make sure that the mains power adapter is correctly connected to the recharging base. ­ If the mains power adapter is connected correctly, the red CHARGE LED on the recharging base lights up. ­ Totally empty batteries will take up 12-14 hours to fully recharge. [. . . ] Signals from the transmitter may also be blocked when the set is used in an environment with a lot of radio frequency (RF) interfernce. If the beeping cannot be stopped by using one of the options mentioned above: · Note: When you have switched off the receiver's beeping manually you will no longer know whether it receives signals or not. Therefore put the switch back in its original position when you are going to use the set again. Koppla en av de medföljande nätadaptrarna till Barnvaktens sändarenhet och den andra till mottagarenhetens basenhet (fig. [. . . ]