User manual PHILIPS SBCSC368

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PHILIPS SBCSC368. We hope that this PHILIPS SBCSC368 user guide will be useful to you.

Lastmanuals help download the user guide PHILIPS SBCSC368.


Mode d'emploi PHILIPS SBCSC368
Download
Manual abstract: user guide PHILIPS SBCSC368

Detailed instructions for use are in the User's Guide.

[. . . ] Make sure the Baby unit and adapter cable are always out of reach of the baby, at least 1 metre away. Never place the Baby unit inside the baby's bed or playpen!The antennas on the Parent and Baby units are fixed; do not try to extend them. Never cover the Baby unit (with a towel, blanket, etc. [. . . ] Set the SENSITIVITY control (A-5) on the Baby unit to about mid-range (5). The green TRANSMIT light (A-3) lights when a sound is picked up. Move away from the Baby unit with the Parent unit. Switch on the Parent unit using the Volume control/Off (B-5) and adjust the volume to the level you prefer. If required, re-adjust the SENSITIVITY control (A-5) on the Baby unit to set the level at which the microphone will start to pick up sounds. Experiment with different levels until you find the setting that suits you and your baby best. The green LINK light (B-1) lights continuously when the Parent unit and the Baby unit are in touch with each other. Both units use anti-interference technology to reduce the chance of interference from other signals. If interference does occur or if sound reception is poor, try switching both units to the other channel to improve the sound quality. Note: Always make sure that the channel selection switches (A-7, B-8) on both units are set to the same position. Checking that the units are in touch The green LINK light (B-1) of the Parent unit lights continuously to show that the Parent unit and the Baby unit are in touch with each other. This light flashes if the Baby unit is out of range for more than 30 seconds or if the signal is blocked. When the units are no longer in touch, try one of the following: · Move the Parent unit closer to the Baby unit. (The maximum operating distance is 250m in ideal conditions. Walls and floors can limit this distance. ) · Switch both units to the other channel. Check that both units are powered correctly (low batteries?If you wish, you can switch on a special feature that lets you hear an audible warning on the Parent unit when the units are not in touch. The Parent unit is delivered with this beep switched off to avoid intermittent disturbances that can occur when the connection is interrupted for a short period. To switch on the audible warning, open the Parent unit's battery compartment cover (B-9) and set the switch (B-12) inside to the On position ( ). [. . . ] Mobile or cordless phones too close to the baby monitor can cause interference. Only use the AC power adapter included or a type that complies with safety standard EN60950 and that has the following specification: 9 Volt DC / 200mA. ­ Continuous communication link (hidden signal ensures a continuous link between both units so you only hear your baby's sounds). A-1 A-2 A-3 A-4 A-5 A-6 A-7 A-8 A-9 Mikrofon ---------------------------Lampa strömmen påkopplad --Lampa överföring ----------------Tryckknapp ström POWER ----Mikrofonkänslighet ---------------Uttag likström --------------------Brytare kanalval ------------------Lock batterifack ------------------Adapter växelström -------------högkänslig mikrofon lyser när enheten aktiveras; blinkar när batterierna är nästan tomma lyser när ljud överförs tryck på denna knapp för att sätta på eller stänga av enheten ställ in nivån på vilken mikrofonen fångar upp ljud stick in nätadaptern i detta uttag välj kanal A eller B (den som har minst störning) skruva loss och ta av för att sätta i batterier stick in i växelströmsnätuttaget och i uttaget för likströmtillförsel Stänger av strömmen till enheten helt sätt enheten i stället för användning på nätström och när batterierna är nästan tomma praktisk klämma för att bära med sig enheten välj kanal A eller B (samma som babyenheten) ta av för att byta batterier stick in nätadaptern i detta uttag stick in i växelströmsuttaget i uttaget för likströmtillförsel kopplar det akustiska larmet på och av lyser när enheten står i stället och laddas upp Koppla växelströmsadaptern (A-9) till ett växelströmsnätuttag, och anslut sladden till likströmtillförseluttaget (A-6) på babyenheten. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PHILIPS SBCSC368

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PHILIPS SBCSC368 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag