User manual PHILIPS SBCSC369

[. . . ] Walls, ceilings, large objects and even glass affect the operating range. The more obstacles in between, the shorter the operating range) ­ 10°C to 40°C 8 9 Continuous transmission ­ the baby unit now monitors sounds continually as long as it is switched on. This feature means that you can be confident of hearing any sounds your baby makes at all times. Transmission frequencies BIG PARENT UNIT SBC SC369/05 (IRE, UK): C-1 C-2 C-3 C-4 Power light -------------------------System check light ----------------Loudspeaker -----------------------Loudspeaker Volume control / Off switch ------------------------Sound-level lights -----------------Battery compartment cover ----Channel selection switch -------DC power supply socket -------AC power adapter ---------------lights when unit is powered; flashes when batteries are low lights to show that both units are in touch with each other provides clear sound · set loudspeaker level; · switches off the power to the unit completely the more sound your baby makes, the more lights that light unscrew and unclip to replace batteries select channel A or B (same as Baby unit) plug mains adapter connector into this socket plug into AC mains socket and into DC power supply socket Channel A 49. 890 MHz Channel B 49. 830 MHz SBC SC369/05 R&TTE Directive 1999/5/EC BE IRE PT DE DK IT FI CH GR LU SE ES NL UK FR AT NO C-5 C-6 C-7 C-8 C-9 0682 IMPORTANT! [. . . ] Replace rechargeable battery pack. Small Parent unit The small Parent unit uses a rechargeable battery pack. This is already installed, but first it must be charged for at least 14 hours as follows before using the unit outside the charging base: · Connect the AC power adapter (B-11) to an AC mains socket, and then connect the cord to the DC power supply socket (B-10) of the charging base (B-6). · Place the small Parent unit inside the charging base. The small Parent unit can be operated now but you should leave it in the charging base until the batteries are fully charged (at least 14 hours). When the batteries are fully charged, take the small Parent unit out of the charging base and use cordlessly for up to 12 hours. When the red POWER light (B-2) on the small Parent unit flashes, the battery power is low. Place the small Parent unit inside the charging base to recharge the batteries. High pitched noise. Units are too close together. Volume too high. Parent unit batteries do not charge. Battery life is at an end. No sound. Volume control on Parent unit is set too low. Units are out of range. Turn volume control/Off switch clockwise (B-4, C-4). Big Parent unit Move Parent unit closer to Baby unit. Baby unit:- replace batteries or connect to mains power. Connect the AC power adapter (C-9) to an AC mains socket, and then connect the cord to the DC power supply socket (C-8) of the big parent unit. If you want to use batteries, remove the battery compartment cover (C-6) using a screwdriver. Insert four 1. 5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw. [. . . ] When the units are no longer in touch, try one of the following: · Move the Parent unit closer to the Baby unit. (The maximum operating distance is 200m in ideal conditions. Walls and floors can limit this distance. ) · Switch all units to the other channel. [. . . ]