User manual PHILIPS SBCSC467

[. . . ] products whose reliability and operating quality bring reassurance. You can trust this Philips baby monitor to provide round-theclock support by ensuring you can always hear your baby clearly, no matter where you are in the house. Getting your baby monitor ready Position the Baby unit at least one metre away from your baby. Never place the baby unit inside the baby's bed or playpen. [. . . ] Push the power button on the Baby unit to turn it on. Adjust the volume on the Baby unit to about mid-range using VOLUME control. Later you can adjust the volume of baby unit's loudspeaker to a level you prefer. Adjust the volume on the Parent unit to the lowest level using the VOLUME ON/OFF control (do not switch off). > the sound-level lights visually alert you to baby's sounds. The more sound your baby makes, the more lights light. Switch the Parent unit on and adjust the volume to the level you prefer using the VOLUME ON/OFF control. On the Parent unit, press and hold the talk button and talk clearly into the microphone. While the talk button on the Parent unit is being pressed, no sounds from the Baby unit can be heard on the loudspeaker of the Parent unit. Checking that the units are in touch Check that the digital SYSTEM CHECK light on the Parent unit lights continuously (green) to confirm that the connection between both units is reliable. If the light flashes (red), move the Parent unit closer to the Baby unit. The light flashes if the units are out of range for more than 30 seconds or if there is interference. Using the family intercom system Push the power button on the Baby unit to turn it on. Adjust the volume on the Baby unit to about mid-range using the VOLUME control. Set the sensitivity level on the Baby unit to zero. Switch the Parent unit on and adjust the volume to the level you prefer using the VOLUME ON/OFF control. On the Parent unit, press and hold the talk button and talk clearly into the microphone. You can switch on the system check alarm on the Parent unit that beeps when the units are not in touch. [. . . ] Loudspeaker volume on Baby unit is Set VOLUME control on baby unit to too low. Only use the AC power adapter included or a type that complies with safety standard EN60950 and that has the following specification: input 230V AC, 50 Hz; output 9 Volt DC / 200mA. Continuous communication link (hidden signal helps reduce interference and ensures a continuous link between both units so you only hear your baby's sounds). Mobile or cordless phones too close Move phones away from the units. [. . . ]