User manual PHILIPS SBCSC468

[. . . ] Connect the AC power adapter (A-9) to an AC mains socket, and then connect the cord to the DC power supply socket (A-6) of the Baby unit. If you want to use batteries, remove the battery compartment cover (A-8) using a screwdriver. Put the cover back in place and tighten screw. The Baby unit operates cordlessly for up to 30 hours on fresh batteries. [. . . ] Note: To switch off the Baby unit completely push the POWER button (A-4) . These are already installed, but first they must be charged for at least 14 hours as follows before using the unit outside the charging base: · Connect the AC power adapter (B-11) to an AC mains socket, and then connect the cord to the DC power supply socket (B-10) of the charging base (B-6). The Parent unit can be operated now but you should leave it in the charging base until the batteries are fully charged (at least 14 hours). When the batteries are fully charged, take the Parent unit out of the charging base and use cordlessly for up to 12 hours. When the red POWER light (B-1) on the Parent unit flashes, the battery power is low. place the Parent unit inside the charging base to recharge the batteries. If the rechargeable batteries begin to lose their effectiveness, replace them with four new batteries (1. 2V, AA NiMH) as follows: remove the battery compartment cover (B-7) using a screwdriver and insert the batteries noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw. To use the units to listen to your baby: · Position the Baby unit at least 1 metre away from the baby so that the microphone (A-1) can pick up baby's sounds. ) · Switch both units to the other channel. Check that both units are powered correctly (low batteries?If you wish, you can switch on a special feature that lets you hear an audible warning on the Parent unit when the units are not in touch. The Parent unit is delivered with this beep switched off to avoid intermittent disturbances that can occur when the connection is interrupted for a short period. To switch on the audible warning, open the Parent unit's battery compartment cover (B-7) and set the ). Switch (B-12) inside to the On position ( Note: The LINK light (B-2) continues to operate even if the audible warning is switched off. When the batteries of the Parent unit are charged, the unit can be carried around giving you freedom of movement while still monitoring your baby. Use the belt clip (B-9) to attach the unit to your clothing and so keep your hands free. Power light does not light (Parent unit). AC adapter is not plugged in or Batteries are exhausted. [. . . ] AC adapter plugged into an outlet that is not working. If the power socket has a switch, turn it on. Turn volume control on Parent unit counter-clockwise. Volume control on Parent unit is set too low. [. . . ]