User manual PHILIPS SBCVS400

[. . . ] This document is printed on chlorine free produced paper Printed in Italy Specifications and design are subject to change without notice Short plastic cover H. For cleaning your unique Neo-liteTM TV Support just use lukewarm soapy water and no solvents. [. . . ] Do not overload the support (see technical features). Ensure that the support is rigidly fixed to the wall at each and every one of its holding points. Ne montez pas le support sur une plaque de plâtre ou un mur fait d'un matériau qui pourrait au fil du temps entraîner une instabilité du support monté. Close the cable canal with the plastic covers (short and long) and the rubber covers and make sure that they are in the correct position (figure J). Check that everything is working correctly and that the support can rotate without damaging the cables (figure I). Mounting with audio-video supports and coupling elements If you want to use the TV support in combination with audiovideo supports ­ SBC VS010, and coupling elements ­ SBC VS005, it is important that you start measuring and mounting from the skirting board up, so that the height will always be correct (see figure C, D2 and L). Use the plastic spacers supplied (marked with S) to be sure that the wall plates are always mounted at the right level - (see also Instructions For Use SBC VS010). Si vous souhaitez utiliser le support TV en combinaison avec les supports audio-vidéo ­ SBC VS010, et les éléments de couplage ­ SBC VS005, il importe de commencer à mesurer et à monter à partir du filet d'embase de manière à ce que la hauteur soit toujours correcte (voir la figure C, D2 et L). Insert the safety belt carefully through the tensioning roller as shown in figure H, pass the safety belt around the TV set and insert the end also into the slot in the tensioning roller. Cut off excess belt leaving at least 3-4 cm free. Tighten the belt as much as possible by turning the tension roller clockwise with the supplied Allen wrench, and make sure that it is completely blocked. Use the drilling template to position the location of the five holes correctly (figure C). [. . . ] Position the pre-assembled arm from below upwards on the wall plate and make sure that the locking block slides over the locking rail inside the wall plate cover (figure D1 and D3). Lock the arm with the socket head screw E3 and then lock the screws B2 firmly. [. . . ]