User manual PHILIPS SBCVS500

[. . . ] For cleaning your unique Ultra-lite TV Support just use lukewarm soapy water and no solvents. Close the cable canal totally with the upper closing plate and plastic covers (2). [. . . ] Do not mount the support on plaster board or a wall made of material that could lead to the instability of the mounted support over time. Do not overload the support (see technical features). Ensure that the support is rigidly fixed to the wall at each and every one of its holding points. Do not expose the support to extreme temperatures, acids or solvents. Ne montez pas le support sur une plaque de plâtre ou un mur fait d'un matériau qui pourrait au fil du temps entraîner une instabilité du support monté. Close the cable canal with the rubber covers and make sure that they are in the correct position (figure H). Check that everything is working correctly and that the support can rotate without damaging the cables (figure G). Mounting with audio-video supports and coupling elements If you want to use the TV support in combination with audiovideo supports ­ SBC VS010, and coupling elements ­ SBC VS005, it is important that you start measuring and mounting from the skirting board up, so that the height will always be correct (see figure C and J). Use the plastic spacers supplied (marked with S) to be sure that the wall plates are always mounted at the right level - (see also Instructions For Use SBC VS010). Montage avec supports audio-vidéo et éléments de couplage Si vous souhaitez utiliser le support TV en combinaison avec les supports audio-vidéo ­ SBC VS010, et les éléments de couplage ­ SBC VS005, il importe de commencer à mesurer et à monter à partir du filet d'embase de manière à ce que la hauteur soit toujours correcte (voir la figure C et J). You can use the template as a plumb line to ensure a vertical alignment. To obtain a precise hole, drill a small hole first and then enlarge to 10 mm diameter. [. . . ] Tighten the belt as much as possible by turning the tension roller clockwise with the supplied Allen wrench, and make sure that it is completely blocked. Fix the pre-assembled arm on the wall by tightening the bolts in the bolt anchors with the supplied pipe wrench (10) to ensure their holding capability (figure D). [. . . ]