User manual PHILIPS SBT30GRN

[. . . ] do not use the appliance on freshly washed hair. Note: Make sure the head of the person whose hair you are cutting is at the same level as your chest. This ensures that all parts of the head are clearly visible and within easy reach. Use the small comb for a hair length of 3-21mm and use the large comb for a hair length of 24-42mm. [. . . ] Make sure that the arms of the comb have been slid properly into the grooves on both sides. Hair length settings The settings are shown on the arms of the comb. The settings correspond to the remaining hair length after cutting (Fig. The small comb cuts the hair to a length of 3mm, 6mm, 9mm, 12mm, 15mm, 18mm or 21mm. The large comb cuts the hair to a length of 24mm, 27mm, 30mm, 33mm, 36mm, 39mm or 42mm. Make overlapping passes over the head to ensure that the appliance catches all the hairs that need to be cut. Make sure that the flat part of the comb is fully in contact with the scalp to obtain an even cutting result. To achieve a good result with curly, sparse or long hair, you can use the styling comb to guide the hair towards the appliance. Regularly remove cut hair from the comb. If a lot of hair has accumulated in the comb, remove it from the appliance and blow and/or shake the hair out of it. You can use the clipper without comb to contour the neckline and the area around the ears. If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. Do not use the appliance if the cutting unit or the combs are damaged or broken, as this may cause injury. This appliance is only intended for clipping human scalp hair. Do not use the appliance in the bath or in the shower. Never immerse the appliance in water or any other liquid, nor rinse it under the tap. General The adapter transforms 100-240 volts to a safe low voltage of less than 24 volts. Note: Make sure that the flat part of the comb is fully in contact with the scalp to obtain an even cutting result. Tips: Start clipping at the highest hair length setting of the comb and reduce the hair length setting gradually. Write down the hair length settings you use to create a certain hairstyle as a reminder for future clipping sessions. To clip most effectively, move the appliance against the hair growth direction. Try different directions (upward, downward or across), because hair doesn't all grow in the same direction. [. . . ] To clip most effectively, move the appliance against the hair growth direction. Try different directions (upward, downward or across), because hair doesn't all grow in the same direction. If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Preparing for use Charge indications Charging When you charge the appliance, the battery light flashes green to indicate that the appliance is charging. [. . . ]