User manual PHILIPS LUMEA 2 SC2001/01

[. . . ] Register your product and get support at www. Com/welcome SC2001/01 1 English 6 Français 28 71 90 SC2001/01 6 English Table of contents Introduction 7 Benefits 7 Intense Pulsed Light (IPL) technology for home use 7 Effective hair regrowth prevention for everyday smoothness 7 Gentle treatment, even on sensitive body areas 8 Cordless operation for maximum freedom and flexibility 8 Lamp does not require replacement 8 How Philips’ Intense Pulsed Light technology works 8 Hair growth 8 Working principle 8 General description 8 Important 9 Danger 9 Warning 9 To prevent damage: 10 Caution 10 Keep the following things in mind to avoid compromising the lifetime of your Philips Lumea: 10 For whom is Philips Lumea not suitable?10 Contraindications 10 Never use the appliance if you are pregnant or breast feeding. 10 Never use the appliance if you have an unsuitable skin and/or hair colour, i. [. . . ] 6 Press the safety ring fully onto the skin with slight pressure. Note:The safety ring has contact switches that together are the safety system of the appliance. This safety ring prevents unintentional flashing without skin contact. , , The ‘ready to flash’ light on the back of the appliance lights up green when all contact switches of the safety ring are in contact with the skin and the appliance is charged. Tip: For easier use,  stretch the area of skin you want to treat. On areas with softer skin, you may need to exert more pressure on the appliance to push in all contact switches. 7 Press the flash button to release a flash. Note:The visible light produced by the appliance is the reflection of the flash on the skin and is harmless to your eyes. It is not necessary to wear goggles during use. 8 Let go of the flash button after the appliance has flashed. 9 For the next flash, repeat steps 6 to 9. 5 seconds until the appliance is ready to flash again. Do not treat exactly the same area multiple times during one session. This does not improve the effectiveness of the treatment, but increases the risk of skin reactions. 18 English 10 To avoid untreated areas, always make sure there is some overlap with the previously treated area when you place the appliance on the skin. The effective light only comes out of the light exit window. Make sure the flashes are produced close to each other. 11 Switch off the appliance after you have finished the treatment. 12 Check the light exit window and the attachment for hairs and dirt and clean the appliance after use (see chapter ‘Cleaning and maintenance’). Guidelines for treatment Average treatment time Area Underarms Bikini line Entire bikini area One lower leg One full leg Approx. 5 minutes per side 5 minutes 12 minutes 20 minutes Note:The average treatment times above have been observed during research and tests. Individual treatment times may vary from person to person. [. . . ] €See chapter ‘Preparing for use’, section ‘Setting the light intensity. If the skin reaction lasts longer than 3 days, contact your doctor. the hair-removal results are not satisfactory. You have used a light intensity which is too low for you. [. . . ]