User manual PHILIPS SCD137

[. . . ] 2 Connect the AC power adapter (A-4) to a wall outlet. The baby unit is now ready for mains operated use. Battery operated use 1 Remove the battery compartment cover (A-10) of the baby unit, using a coin. Getting your baby monitor ready 2 Insert four 1, 5V AA batteries, noting the + and ­ configuration inside the battery compartment (batteries are not supplied, we recommend Philips Alkaline batteries). [. . . ] > The POWER light (B-10) lights up green. > When connection has been established between the units, the LINK light (B-8) on the parent unit lights up green. 4 Position the baby unit at least 1 meter / 3 feet away from your baby. 5 Position the parent unit at the desired place within the operating range of the baby unit but at least 1 meter / 3 feet away from the baby unit. for more information on the operating range see `Technical specifications'. Always make sure that the CHANNEL selection switches (A-9, B-11) inside the battery compartments on both units are set to the same position!With the CHANNEL selection switches (A-9, B-11) you can select sixteen different channel positions. If you experience interference from other baby monitors, radio devices, etc. Parent unit: slide down the cover (B-12). If you are operating the baby unit on battery power, remove the batteries from the unit. Make sure both units are set to the same channel. Question Why does a new rechargeable battery pack has no full operating time capacity after the first charge?My rechargeable battery pack has very short duration, why?Answer It takes about 3 times full recharge and discharges before the rechargeable NiMH batteries have their full capacity available. Leaving the rechargeable battery pack continuously connected to a charging unit can shorten it's lifetime. If the product is not used for some time, the charged battery pack slowly looses it's load. This is normal; a short recharge will bring it back to it's full capacity again. The charging light (B-6) is always activated as soon as the parent unit is installed. It gradually dims when the batteries are fully charged but remains lit, indicating that the parent unit is powered. At this point your battery is probably completely empty. After some 30 minutes of charging it will be possible to switch the parent unit on, while installed on the charging unit. The charging light (B-6) on the parent unit charging base (B-5) remains lit red, even after the full charge duration. [. . . ] 3 Carefully connect the new battery pack to the power plug and place inside the battery compartment. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. please inform yourself about the local separate collection system for electrical and electronic products. [. . . ]