User manual PHILIPS SCD-254

[. . . ] Please take a few minutes to read through the ENTIRE INSTRUCTION LEAFLET before using your Digital Steriliser for the first time. Do not remove the lid until the 6 minute sterilising cycle has ended. This is indicated by 5 beeps and 3 bars being displayed. It is recommended to let the steriliser cool down for 3 minutes after the sterilising cycle has been completed. [. . . ] The unit will immediately enter a new sterilisation phase and continue the 24 hour cycle from where it was interrupted. Wash your hands thoroughly before removing the sterilised items. If necessary, shake excess water from items before assembling. The tongs can be used to remove small items and to pull the sterile teats through the screw rings of the bottles. Removed items must be used/assembled immediately or re-sterilised. Expressed milk can be stored in a sterile breast milk container in the refrigerator for up to 48 hours (not in the door) or in the freezer for up to 3 months. Infant formula should be made up fresh for each feed. After each cycle the unit should be allowed to cool for at least 3 minutes before opening and removing parts. If after a Mode 1 cycle is run the unit must be allowed to cool for a minimum of 10 minutes prior to running another sterilisation cycle. Sterilising in Mode 1 ­ 6 hour sterile period Sterilising in Mode 2 ­ 24 hour sterile period (see diagram C , page 3) To sterilise up to six 125ml, 260ml or 330ml AVENT Bottles Before each use, wash items in mild soapy water and rinse. Slide the lower basket onto the central stem. thread 2 screw rings onto the central stem. Slide the bottle rack down the central stem, with the neck facing down, until it rests on the top screw ring. Place the teats through the centre of the holes in the bottle rack onto the lower basket. Place inverted bottles in the bottle rack and push the upper basket onto the central stem until it rests on the catch. The upper basket is not required when sterilising 330ml bottles. Place the assembled unit into the steriliser body and put the lid on. Put the lead into the back of the steriliser body and plug into the mains supply. To select Mode 1, press the control button once and the mode number will be displayed. To run this mode, hold the control button in for 2 seconds, then release. OR To select Mode 2, press the control button twice and the mode number will be displayed. To run this mode, hold the control button in for 2 seconds, then release. [. . . ] Switch off, remove water, (take care if the steriliser body is hot) and replace with 90ml of water for use with Mode 1 OR 200ml of water for use with Mode 2. Switch off, remove water, (take care if the steriliser body is hot) and replace with 90ml of water for use with Mode 1 OR 200ml of water for use with Mode 2. Care of your steriliser Using pre-boiled or filtered water in your Digital Steriliser can reduce limescale build up. You should de-scale your steriliser every four weeks, or as often as needed in hard water areas, to ensure it continues to work 100% effectively. [. . . ]