User manual PHILIPS SCD450

[. . . ] To prevent electric shock, do not open the inside of the baby unit and parent units (except for the battery compartment covers) · The antennas on all three units are fixed; do not try to extend them. Getting your baby monitor ready When batteries are installed, you have an automatic back up in case of mains failure. Mains operated use 1 Connect the power adapter cord to the power supply jack (DC 9V --<+ - A-3) of the baby unit. 2 Connect the AC power adapter (A-4) to a wall outlet. [. . . ] Large parent unit: use a screwdriver and slide down the cover (B-11). Small parent unit: slide down the cover (C-13). 2 Lift up the rechargeable battery pack of the small parent unit (C-14). If you are operating the baby unit and the large parent unit on battery power, remove the batteries from both units. Make sure all units are set to the same channel. With the microphone sensitivity switch (A-8) on the baby unit, you can set the sound, coming from the baby unit, to the desired level: low, mid or high. When set to the maximum level, the baby unit monitors all sounds. You can only change the microphone sensitivity if the connection between the baby unit and the parent units is established (when the LINK lights (B-7, C-9) light continuously green). ⷠUse the microphone sensitivity switch (A-8) to adjust the baby unit microphone sensitivity to the desired level. You can use your own voice as a sound reference. > The POWER light (A-7) on the baby unit lights up yellow when a sound is picked up. Do not switch off the parent units completely!> The sound level lights (B-1, C-1) on the parent units visually alert you to baby's sounds. The more sounds your baby makes, the more lights you will see. > When no sound is detected all sound level lights (B-1, C-1) will be off. Note:You can also monitor baby silently on only one of the parent units The LINK alarm will beep when connection between the units is lost. Large parent unit: use a screwdriver and slide down the cover (B-11). Small parent unit: slide down the cover (C-13). (small parent unit) You can carry the small parent in and around your house, giving you freedom of movement while still monitoring your baby. connecting the belt clip · Insert the little spindle on the rear of the belt clip into the recess on the rear of the parent unit. Turn the belt clip to the left until it clicks in position. Turn the belt clip to the right (TURN 2) and take it off. [. . . ] Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. [. . . ]