User manual PHILIPS SCD464

[. . . ] To prevent electric shock, do not open the inside of the baby unit and parent unit (except for the battery compartment cover). The antennas on both units are fixed; do not try to extend them. Getting your baby monitor ready When batteries are installed, you have an automatic back up in case of mains failure. Mains operated use 1 Connect the power adapter cord to the power supply jack (DC 9V --<+ - A-2) of the baby unit. [. . . ] If you do experience interference, try switching to another channel. With the microphone sensitivity control (A-7) on the baby unit, you can set the sound, coming from the baby unit, to the desired level: low, mid or high. When set to the maximum level, the baby unit monitors all sounds. If no sound is picked up, the baby monitor will not monitor since continuous transmission is prohibited by law. You can only change the microphone sensitivity if the connection between the baby unit and the parent unit is established (when LINK light (B-3) on the parent unit lights continuously green). Use the microphone sensitivity switch (A-7) to adjust the baby unit microphone sensitivity to the desired level. You can use your own voice as a sound reference. > The POWER light (A-6) on the baby unit lights up yellow when a sound is picked up. Use the ON/OFF switch / VOLUME control (B-8) on the parent unit to set the volume to the lowest level. Do not switch off the parent unit completely!> The sound level lights (B-1) on the parent unit visually alert you to baby's sounds. The more sounds your baby makes, the more lights you will see. > When no sound is detected all sound level lights (B-1) will be off. The LINK alarm will beep when connection between the units is lost. 3 Slide the battery compartment cover (B-11) back in place until it clicks in position. If the parent unit is operating on batteries, you can carry it in and around your house, giving you freedom of movement while still monitoring your baby. connecting the belt clip · Insert the little spindle on the rear of the belt clip into the recess on the rear of the parent unit. Turn the belt clip to the left until it clicks in position. Turn the belt clip to the right (TURN 2) and take it off. Turn VOLUME control (B-8) on parent unit downwards. set channel selection switches (A-8 , B-7) to the same position on both units. Switch both units to another channel using the channel selection switch (A-8, B-7). [. . . ] Clean the baby monitor with a damp cloth · dispose of used batteries in an environmentally friendly manner · Do not mix old and new batteries or different types of batteries. Remove batteries if the baby monitor is not to be used for long periods of time. If the batteries are left in the unit when it is powered from the mains, check them for leakage every six months. If you have any questions about the SCD464, please contact our helpline for assistance! [. . . ]