User manual PHILIPS SCD465

[. . . ] It is not a substitute for responsible and proper adult supervision and should not be used as such. , Check if the voltage indicated on the adapters of the baby unit and the charger corresponds to the local mains voltage before you connect the appliance. , Do not expose the baby monitor to extreme cold or heat or to direct sunlight. , Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/ feet away). [. . . ] Talk function You can use the TALK button on the parent unit to talk to your baby (e. 1 Press and hold the TALK button and talk clearly into the microphone (Fig. Release the TALK button when you have finished talking. Note:When you press the TALK button, you can no longer hear your baby. Silent baby monitoring 1 Briefly press the volume down (­) button on the parent unit until the volume is switched off completely (Fig. The volume is completely switched off when all sound level lights are out. , As long as the baby unit does not detect a sound, all sound level lights on the parent unit are out (Fig. , When the baby unit picks up a sound, one or more sound level lights on the parent unit come on. The louder the sound, the more lights come on. Press the nightlight button Q again briefly to switch off the nightlight. , The nightlight dims gradually before it goes out completely. If you press the buttons too long, they do not work. Playing lullabies To play or stop a lullaby: 1 Select |K by pressing the ­ and + buttons and confirm by pressing the OK button. Select : to play the last played lullaby again or <| to stop playing. Adjusting microphone sensitivity You can set the microphone sensitivity of the baby unit to the desired level. You can only change the microphone sensitivity when a connection between the baby unit and the parent unit has been established, i. When the LINK light on the parent unit lights up green continuously. Select the desired microphone sensitivity level for the baby unit by pressing the ­ and + buttons and confirm by pressing the OK button. , one light on = minimum sensitivity level , all lights on = maximum sensitivity level Sound alert on/off If the sound alert is switched on, the parent unit beeps as soon as the fifth sound level light lights up blue while the volume is switched off. Setting room temperature range You can set the temperature range (minimum and maximum temperature) for your baby's room. Note:When the maximum temperature selected is lower than the room temperature, the unit consumes more power because the display is on continuously. This is also the case when the minimum temperature set is higher than the room temperature. [. . . ] Why does the charging time of the parent unit exceed 8 hours? the specified operating range of the baby monitor is 300 metres/900 feet. Why does my baby monitor manage a much smaller distance than that?Why is the connection lost every now and then? [. . . ]