User manual PHILIPS SCD468

[. . . ] To prevent electric shock, do not open the inside of the baby unit and parent unit (except for the battery compartment cover). ⷠThe antennas on both units are fixed; do not try to extend them. Getting your baby monitor ready When batteries are installed, you have an automatic back up in case of mains failure. Mains operated use 1 Connect the power adapter cord to the power supply jack (DC 9V --<+ - A-3) of the baby unit. [. . . ] With the microphone sensitivity switch (A-8) on the baby unit, you can set the sound, coming from the baby unit, to the desired level: low, mid or high. When set to the maximum level, the baby unit monitors almost all sounds. You can only change the microphone sensitivity if the connection between the baby unit and the parent unit is established (when the LINK light (B-8) lights continuously green). ⷠUse the microphone sensitivity switch (A-8) to adjust the baby unit microphone sensitivity to the desired level. You can use your own voice as a sound reference. > The POWER light (A-7) on the baby unit lights up yellow when a sound is picked up. Use the ON/OFF switch / VOLUME control (B-9) on the parent unit to set the volume to the lowest level. Do not switch off the parent unit completely!> The sound level lights (B-1) on the parent unit visually alert you to baby's sounds. The more sounds your baby makes, the more lights you will see. > When no sound is detected all sound level lights (B-1) will be off. The LINK alarm will beep when connection between the units is lost. 3 Slide the battery compartment cover (B-12) back in place until it clicks in position. If the parent unit is operating on batteries, you can carry it in and around your house, giving you freedom of movement while still monitoring your baby. connecting the belt clip · Insert the little spindle on the rear of the belt clip (B-15) into the recess on the rear of the parent unit. Turn the belt clip (B-15) to the left until it clicks in position. Turn the belt clip (B-15) to the right (TURN 2) and take it off. set channel selection switches (A-9 , B-11) to the same position on both units. replace battery pack (B-14) of parent unit. Switch both units to another channel using the channel selection switch (A-9, B-11) Recharge battery pack in time. There are too many walls and/or ceilings between baby unit and parent unit. Parent unit located too close to a window and picking up interfering signals from other appliances. [. . . ] Please act according to your local rules and do not dispose of your old products with your normal household waste. The correct disposal of your old product will help prevent potential negative consequences for the environment and human health. Clean the baby monitor with a damp cloth · dispose of used batteries in an environmentally friendly manner · Do not mix old and new batteries or different types of batteries. ⷠIf the batteries are left in the unit when it is powered from the mains, check them for leakage every six months. [. . . ]