User manual PHILIPS SCD469

[. . . ] This baby monitor consists of a parent unit and a baby unit. It provides round-the-clock support by ensuring that you can always hear your baby clearly. When the units are connected properly, you have the certainty that you can hear your baby wherever you are in or around your home or garden. When the regular baby monitor is out of range, simply connect it to your phone or mobile phone. [. . . ] 6) When you run the baby unit on batteries, switch off the nightlight to save power. Dial-up mode In this mode, the baby unit calls a preprogrammed phone number if a sound is detected. You can also phone the phone number to which the baby unit is connected to check on your baby. setting the baby monitor up for dial-up mode 1 Switch on the baby unit and the parent unit. Make sure that: the telephone cable supplied is connected to the phoneline-in socket of the baby unit. At least one telephone number is stored in the memory of the baby unit. Press the MODE button on the baby unit to set the unit to dial-up mode. 15) Note:If Ç lights up on the display, there is no connection to the telephone network. Follow the steps in `Preparing the baby monitor for dial-up mode' to establish a connection with the telephone network. 1) If you have used Quick Install to enter a telephone number in the memory, press M1. If you have programmed the baby unit with the PRG button, choose one of the telephone numbers stored in the memory (M1-M5). Tip:We advise you to test the dial-up function before you leave by making a sound close to the baby unit. Of course, this is easiest when you have programmed your mobile phone number. Answering a call of the baby monitor When the baby unit picks up a sound, it calls the preprogrammed telephone number after the preset sensitivity time. If the call is not answered, the baby unit calls again after 1 minute. 1 Answer the phone to listen to your baby. Press the # button on the telephone to talk to your baby. Replacement parent unit If the battery pack of the parent unit needs to be recharged more often than usual, replace it with a new one. You can obtain a new battery pack at the shop where you bought the baby monitor. 1 Turn the locking knob in the bottom a quarter turn (1) and slide the battery compartment lid downwards to remove it (). Remove the old battery pack from the battery compartment and pull the connector of the old battery pack out of the socket. Insert the connector of the new battery pack into the socket and place the new battery pack in the battery compartment. [. . . ] Perhaps you did not insert the telephone cable properly into the phoneline-in socket of the baby unit. If the baby unit is connected properly to the telephone line, the display shows Å. We advise you to test the dial-up mode before you leave. You did not store a telephone number in the memory of the baby unit. [. . . ]