User manual PHILIPS SCD487

[. . . ] Do not expose the baby monitor to extreme cold, heat or light (e. To prevent electric shock, do not open the case of the baby unit and parent unit (except battery compartment covers). Getting your baby monitor ready for use When batteries are inserted, you will have an automatic back-up in case of mains failure. Mains operated use 1 Connect the power adapter cord (A-11) to the power supply jack (DC 9V / 300mA - A-10) of the baby unit. [. . . ] With the SENSITIVITY (B-2) and Volume + and ­ (B-10) buttons on the parent unit, you can set the sound from the baby unit to the desired level. When set to the maximum level, the baby unit monitors continuously. All sounds (including your baby's breathing, when loud enough) can be heard on the parent unit. You can only change the microphone sensitivity if the connection between the baby unit and the parent unit is established (when LINK lights (A-2, B-8) light continuously green). 1 Briefly press the SENSITIVITY button (B-2) on the parent unit. > The sound-level lights (B-9) give visual feedback on the current sensitivity level for approximately 2 seconds. Note: If you press the SENSITIVITY button (B-2) and/or the Volume + and ­ buttons (B-10) too long, the microphone sensitivity will not be adjusted. > The sound-level lights (B-9) give visual feedback on the new setting for approximately 2 seconds: - 1 light (1 x orange) = minimum level / lowest sensitivity; - all lights (5 x orange) = maximum level (continuous transmission) / highest sensitivity Note:When the sensitivity level of the baby unit is set to a high level, the unit will consume more power because it is in continuous transmission mode. Briefly press the Volume ­ button (B-10) on the parent unit until the volume is completely switched off. > All sound-level lights (B-9) will now be off. > When no sound is detected, all sound-level lights (B-9) will be off. > When a sound is detected the sound-level lights (B-9) light up orange. 1 Briefly press the night light button ( ) (A-7) on the baby unit to switch on the night light (A-3). 2 Briefly press the night light button ( ) (A-7) again to switch off the night light (A-3). Switch off the night light when operating the baby unit on batteries. Note: If you press the night light button ( ) (A-7) too long, the night light (A-3) will not switch on/off. If the parent unit is operating on batteries, you can carry it in and around your house, giving you freedom of movement while still monitoring your baby. connect · Insert the little spindle on the rear of the belt clip into the recess (B-11) on the rear of the parent unit. Turn the belt clip to the left until it clicks in position. Turn the belt clip to the right (TURN 2) and take it off. When the parent unit is misplaced and the volume is switched off, you can use the PAGE button (A-6) on the baby unit to locate the parent unit. 2 To stop the paging alert, briefly press the page button (A-6) again or any button on the parent unit. [. . . ] The correct disposal of your old product will help prevent potential negative consequences for the environment and human health. In this mode both units can be reset to the default factory settings. Factory initialization can be used if problems occur which can not be solved by following the suggestions in chapter `Troubleshooting'. Resetting must be done separately for each unit. [. . . ]