User manual PHILIPS SCD489

[. . . ] It is not a substitute for responsible and proper adult supervision and should not be used as such. , Check if the voltage indicated on the adapters of the baby unit and the charger corresponds to the local mains voltage before you connect the baby unit and the charger. , Do not expose the baby monitor to extreme cold or heat or to direct sunlight. Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/ feet away). [. . . ] The LINK light on the parent unit then lights up green continuously (Fig. If no link is established after 30 seconds, the LINK light on the parent unit flashes red and the parent unit beeps from time to time. Place the baby unit at least 1 metre/ feet away from your baby (Fig. Make sure it is at least 1 metre/ feet away from the baby unit (Fig. Depending on the surroundings and other disturbing factors, this range may be smaller. Features adjusting loudspeaker volume 1 Briefly press the volume + and ­ buttons on the baby unit until the desired loudspeaker volume for the baby unit has been reached (Fig. Briefly press the volume + and ­ buttons on the parent unit until the desired loudspeaker volume for the parent unit has been reached (Fig. Note: If you press the volume + and ­ buttons too long, the volume is not adjusted. Note:You only have to adjust the baby unit volume when you use the talk function (see below). Note: If the volume is set to a high level, the units consume more power. Adjusting microphone sensitivity You can set the microphone sensitivity of the baby unit to the desired level. This allows you to monitor your baby while you are moving around. Note: If you press the nightlight button Q too long, the nightlight does not come on or go out. Tip: Switch off the nightlight when you operate the baby unit on batteries. To stop the paging alert tone, press the PAGE button again briefly or press any button on the parent unit. Connecting the belt clip 1 Insert the small pin on the back of the belt clip into the opening on the back of the parent unit (1). Turn the belt clip to the left () until it locks into position (`click') (Fig. Disconnecting the belt clip 1 Turn the belt clip to the right (1) and take it out of the opening () (Fig. Connecting the neck strap 1 Insert the small pin at the end of the neck strap into the opening on the back of the parent unit (1). Turn the neck strap to the left () until it locks into position (`click') (Fig. Disconnecting the neck strap 1 Turn the neck strap to the right (1) and take it out of the opening () (Fig. Reset function This function allows you to reset the parent unit and baby unit to the default settings. [. . . ] If the LINK light on the parent unit still does not start to flash, use the reset function to reset the units to their default settings. If the parent unit beeps while the LINK light flashes red, the connection with the baby unit is lost. Move the parent unit closer to the baby unit. If the parent unit beeps, the LINK light flashes red and the battery check light lights up red, the batteries are running low. [. . . ]