User manual PHILIPS SCD491

[. . . ] A-1 A-2 A-3 A-4 A-5 A-6 A-7 A-8 A-9 A-10 A-11 A-12 A-13 IR LEDs Camera lens/focus ring Antenna OFF/ON/ switch Battery compartment cover Wall mount recess CHANNEL selection switch Nightlight Microphone POWER light DC 7. 5V -<+ power supply jack AC power adapter Mounting clip B-1 B-2 B-3 B-4 B-5 B-6 B-7 B-8 B-9 B-10 B-11 B-12 B-13 B-14 B-15 B-16 B-17 POWER light Display Sound level lights Loudspeaker CHANNEL selection switch Mode selection switch (AV AUDIO AUTO) Battery compartment cover ON/OFF switch/VOLUME control Antenna AC power adapter Rotate image switch DC 8. What else you'll need Camera unit (baby unit) Monitor unit (parent unit) What else you need Getting your baby monitor ready Camera unit (baby unit) Monitor unit (parent unit) Channel selection Connecting the monitor to your TV Switching the night-light on and off Rotating the displayed image Monitoring your baby silently Your baby cam consists of a monitor unit (parent unit) and a camera unit (baby unit). With the units properly connected the baby cam provides round-theclock support by ensuring you can always see and hear your baby clearly. [. . . ] 6 Connect the power adapter cord to the unit power supply jack (DC 8. 7 Connect the AC power adapter (B-10) to a wall outlet. unwrap and fully extend the AC adapter cord. 8 Leave the monitor unit connected to the mains supply until the batteries are fully charged (at least 10 hours). > During recharging the POWER light (B-1) blinks red. > When batteries are fully charged the POWER light (B-1) lights continuously green. The monitor unit can now be used cordlessly for at least 3. < The monitor unit is now ready for battery-operated use. The belt clip can be used to support the unit in an inclined position. For this, slide down the belt clip (B-15) and lift it up. Make sure that both units are always set to the same channel. > The POWER light (A-10) lights up green. > The IR LEDs (A-1) are automatically activated so the camera can also be used in low light conditions. > The POWER light (B-1) lights up green. > You will now hear sound from the loudspeaker (B-4) and see picture on the display (B-2). > The sound level lights (B-3) light up when sound is picked up by the camera unit. The more sound is picked up, the more lights light up. If there is interference or if sound reception is poor, try repositioning the units (camera unit first) or set both units to another channel. Make sure that both units are always set to the same channel. Mode selection (Monitor unit) The various modes are selected with the mode selection switch (B-6) at the bottom of the monitor unit. AV (Audio Video) mode Sound and picture are transmitted together continuously. Auto mode Only when sound is detected by the camera unit, sound and picture are transmitted together and picture is shown on the display (B-2). [. . . ] Set both units to another (same) channel (A-7, B-5). Possible cause One or both units close to metal objects. Household Set both units to another (same) appliances, cordless or cellular channel (A-7, B-5). One or both units close to metal objects. [. . . ]