User manual PHILIPS SCD-505

[. . . ] Make sure that your hands are dry when you insert or replace batteries. For the parent unit, charge the supplied rechargeable batteries as described in this user manual. To prevent battery explosion or leakage, which can damage the baby monitor and cause burns and skin or eye irritation: · Remove batteries if you are not going to use the product for more than 30 days, Keep batteries away from excessive heat such as sunshine, fire or the like, · Remove batteries as soon as they run out of power. It is not a substitute for responsible and proper adult supervision and should not be used as such. [. . . ] » The baby unit turns on, and all indicators on the baby unit light up briefly. Keep the baby unit and the mains cord at least 1 metre/3. 5 metres/ 5 feet away from the baby unit to prevent acoustic feedback. Press and hold on the parent unit for two seconds. » The parent unit turns on, and all indicators on the parent unit light up briefly. Use the parent unit in the operating range of the baby monitor. It takes less than 15 seconds to establish the Link between the parent unit and the baby unit. When the parent unit is out of range of the Baby unit, the parent unit beeps from time to time. The battery indicator flashes red and a beep tone occurs 30 minutes before the batteries run out of power. » The link indicator flashes red and the parent unit starts to search for the baby unit. The parent unit beeps from time to time. Outdoors: up to 260 metres/ 850 feet The operating range varies depending on the surroundings and other factors that cause interference. for interference from wet and moist materials , the range loss is up to 100%. For interference from dry materials, see the following table: Material thickness < 30 cm/12 in Loss of range 0-10% When you monitor your baby from a small distance, you can enable ECO mode. In ECO mode, the baby monitor consumes less energy, but still ensures that you can hear your baby clearly without any distracting noise. Make sure that the parent unit is linked to the To enable ECO mode, press and hold on the parent unit for two seconds. » The ECO mode indicator lights up blue and the parent unit reboots. » The ECO mode indicator goes out and the parent unit reboots. » The sound level lights illuminate briefly and indicate the current sensitivity settings on the baby unit. When you hold , turn on the parent unit. Follow the same procedure as you reset the parent unit. If you need service or information or if you have a problem, please visit the Philips AVENT website at www. [. . . ] Switch off the parent unit during charging. If the parent unit is sufficiently charged and there are batteries in the baby unit, the baby monitor continues to operate during a power failure. Grattis till ditt inköp och välkommen till Philips AVENT!Innan du ansluter babyvakten till elnätet bör du se till att spänningen som anges på adaptrarna på babyvakten motsvarar den lokala nätspänningen. [. . . ]