User manual PHILIPS SCD 505 QUICK START GUIDE

[. . . ] Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. For assistance, visit our website www. philips. com/AVENT or FDOO $9(17  p This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www. eiae. org. safetysymbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 6 EN television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. RF Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 7 3/4 inches / 20 centimeters between the radiator and your body. For handheld operation, this equipment has been tested and meets the FCC RF exposure guidelines. For body-worn operation, this product has been tested and meets the FCC RF exposure guideline when used with the accessories supplied with this product. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter. If only one light is on, the minimum sensitivity LV VHOHFWHG , I ÀYH OLJKWV DUH RQ WKH maximum sensitivity is selected. EN 1 2 3 1 Press and hold Press and hold to turn off the parent unit. on the parent unit. When you hold , turn on the parent unit. Follow the same procedure as you reset the parent unit. To reset the baby unit: 12 Recharge the parent unit when you see the low battery icon or hear the low battery alert tone. Fully recharge the parent unit before you use it again, as completely draining the rechargeable batteries may reduce their life. Remove the rechargeable batteries from the parent unit if you are not going to use it for a week or longer. Always fully recharge the parent unit after a long period of disuse. Remove the parent unit from the charging dock after it is fully charged. If you experience any issue with the rechargeable batteries of your parent unit, you may contact your dealer or a Philips service centre. Full two-year warranty Philips Electronics North America Corporation (USA) and Philips Electronics Ltd (Canada) warrant each new Philips AVENT product, model SCD505/00, against defects in materials or workmanship for a period of two years from the date of purchase, and agree to repair or replace any defective product without charge. Important: This warranty does not cover damage resulting from accident, misuse or DEXVH ODFN RI UHDVRQDEOH FDUH RU WKH DIÀ[LQJ RI any attachment not provided with the product. No responsibility is assumed for any special, incidental or consequential damages. In order to obtain warranty service, simply call toll-free 1-800-54-AVENT. EN 13 English Optimize the battery life of the parent unit 6 Warranty 7 Frequently asked questions Why doesn't the link indicator on the parent unit light up when I press on the parent unit? [. . . ] Why does the parent unit react too quickly to other sounds? Remove the sound sources away from the baby unit. Decrease the microphone sensitivity of the baby unit. Why does the parent unit react slowly to the baby's crying? [. . . ]